|Categories||Snow Blower Manuals, Toro Snow Blower|
|Tags||Toro 1132, Toro 38570, Toro 38580, Toro 828|
|Document Type||Operator's Manual|
|Serial Number||2000001 - 2999999|
|Product Name||Toro 828 1132 Power Shift Snowthrower|
|Product Brand||Toro - Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Toro Snow Blower - Snow Blower
|Product Series||Snowthrower, Two Stage Power Shift|
|Engine Manufacturer||Briggs & Stratton|
|Engine Oil Type||48 oz. (1.4l) 5w-30 or 10w / API SF or Higher|
|Gearbox Lubricant||4.5 oz. (133ml) SAE 90 GL5 or higher|
|Engine Motor Model #||252416-0756-01|
|Engine Motor Size||11 hp|
|Engine Motor Type||4 Cycle|
|Transmission Speed||4 Forward/2 Reverse|
|Document File Type|
|Wikipedia's Page||Toro Company|
Thank you very much it was helpful.
cool dude ggccfgbg
FORM NO. 3314-624 Rev. A OPERATOR’S MANUAL 828 and 1132 POWER SHIFT® SNOWTHROWERS A SAFETY INSTRUCTIONS The 828 and 1132 POWER SHIFT SNOWTHROWERS meet or exceed the Outdoor Power Equipment Institute’s safety standards for snowthrowers; thus, Toro proudly displays the OPEl safety seal. To assure maximum safety, best performance, and to gain knowledge of the product, It Is essential that you or any other operator of the snowthrower read and understand the contents of this manual before the englne’ls ever started.
Pay particular attention to the safety alert symbol A which means CAUTION, WARNING OR DANGER – “personal safety Instruction. ” Read and understand the Instruction because It has to do with safety. Failure to comply with Instruction may result In personal Injury. The following instructions are comparable to the Instructions For Safe Snowthrowing adopted by the American National Standards Institute (ANSI). The snowthrower is designed and tested to offer reasonably safe service; however, failure to comply with the following Safety Instructions MAY RESULT IN PERSONAL INJURY. WARNING: Engine exhaust contains carbon monoxide which is an odorless, deadly poison. Carbon monoxide is also known to the State of California to cause birth defects. Do not run engine indoors or in an enclosed area. 6. Adjust both skids so auger housing clears gravel or crushed rock surfaces. 7. Before starting the engine, move speed shift control to N (neutral) and ensure that auger/impeller control and traction (wheel drive) control are in disengaged position. 8. Always use a grounded three wire plug and cord to start snowthrower equipped with an electric starter. Extension cord must be connected to a properly grounded outlet. 9. Fill fuel tank with gasoline before starting the engine. Avoid spilling any gasoline. Since gasoline is highly flammable, handle it carefully. DO NOT SMOKE WHILE HANDLING GASOLINE. A. Use an approved gasoline container. B. Fill fuel tank outdoors, not indoors. NEVER ADD FUEL TO AN ENGINE THAT IS RUNNING OR HOT. Engine must be cool to reduce a potential fire hazard. C. Open doors if engine will be started in the garage because exhaust fumes are dangerous and could possibly be deadly. Do not run engine indoors. D. Wipe up any spilled gasoline. Reinstall gasoline container cap and snowthrower fuel tank cap securely before starting the engine. BEFORE OPERATING 1. Read and understand the contents of this manual before operating the snowthrower. Become familiar with all controls and know how to stop the engine quickly. 2. Keep everyone, especially children and pets, away from area of operation. Never allow children to operate the snowthrower. Adults should operate the snowthrower only after reading this manual. 3. Inspect area thoroughly where snowthrower will be used. Remove doormats, sleds, boards, sticks, wire, and any other foreign objects which might be picked up and thrown by the snowthrower. 4. Keep all shields and safety devices in place. If a shield, safety device, or decal is illegible, damaged or lost, repair or replace it before beginning operation. Also, tighten any loose nuts, bolts or screws. 5. Wear adequate winter clothing and rubber boots that will ensure proper footing on slippery surfaces. Do not wear loose fitting clothing that could possibly get caught in moving parts.