4.
5.
Open valve by rotating valve to the left. This
allows fuel to flow into drain pan.
3.
Clean area around oil drain plug. Next, slide oil
drain pan below drain extension; then remove oil
drain plug (Fig. 22).
Reinstall fuel line and secure with hose clamp.
4.
5.
After all oil is drained, reinstall oil drain plug
and left wheel.
Lubricating Snowthrower
Position snowthrower on a level surface. Next,
fill crankcase with oil: refer to Fill Crankcase
With Oil, page 10. Wipe up any oil that may
have spilled.
Lubricate moving parts of the snowthrower after
every 15 hours of operation.
1.
2.
3.
Pull wire off spark plug and make sure wire does
not contact plug accidentally.
Auger Gear Box Grease
Drain gasoline from fuel tank; refer to Draining
Gasoline, page 14.
The auger gear box grease level must be checked at
time of snowthrower assembly, after every 10 hours
of use and upon removal from annual storage. To
check the auger gear box grease level:
Tip snowthrower forward onto auger/impeller
housing and block it so it cannot fall. Now,
remove four screws holding bottom cover in
place and remove cover (Fig. 20).
1.
2.
Position snowthrower on a level surface.
Pull wire off spark plug and make sure it does
not contact the plug accidentally.
4.
Lightly lubricate snowthrower with light oil and
grease as shown in Figure 21. Wipe up any
excess oil or grease.
3.
4.
5.
Clean area around pipe plug so dirt is removed.
Remove pipe plug from gear box (Fig. 23).
IMPORTANT: Do not get oil or grease on
rubber wheel or friction drive plate because
the wheel will slip and the rubber may
deteriorate.
Check level of grease in gear box. Grease must
be visible through opening.
6.
If level of grease is low, add Lubriplate MAG-1
grease (a low temperature, high pressure grease,
Toro part no. 505–101) to the gear box until
point of overflow.
5.
Reinstall bottom cover with (4) screws.
Changing Crankcase Oil
Note:
Only use low temperature, high
pressure grease in gear box.
Initially, change oil after the first 2 hours of engine
operation; thereafter, under normal conditions, change
oil after every 25 hours of engine operation or
annually, whichever comes first. If possible, run
engine just before changing oil because warm oil
flows better and carries more contaminants than cold
oil.
7.
Reinstall pipe plug in gear box.
Adjusting Auger/Impeller Drive
Belt
If auger/impeller belt slips, resulting in decreased
snowthrowing performance, either an adjustment or a
new belt is required.
1.
Pull wire off spark plug and make sure wire does
not contact plug accidentally.
2.
Block up the rear of the snowthrower chassis and
remove the left wheel.
1.
Pull wire off spark plug and make sure it does
not contact the plug accidentally.
15
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 38062, Toro 622, Toro 9900001 |
| Model Number | 38062 |
| Model Year | 1999 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 9900001 - 9999999 |
| Product Name | Toro 622 38062 Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | Snowthrower, Two Stage Small Frame |
| Swath | 22 inch |
| Discharge | Two Stage |
| Engine Manufacturer | Tecumseh |
| Engine Oil Type | 21 oz. (.62l) 5w-30 or 10w / API SH or higher |
| Gearbox Lubricant | 7 oz. (198gm) Lubriplate MAG-1 |
| Engine Motor Model # | HSK60-76011C |
| Engine Motor Size | 6 hp |
| Engine Motor Type | 4 Cycle CARB1, EPA1 |
| Transmission Speed | 3 Forward/1 Reverse |
| Transmission Type | Friction Disc |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(3 votes, average: 4.67 out of 5)
Lawn and Garden readers have rated Toro 622 38062 Snow Blower Operators Manual, 1999 4.7 out of 5.0 based on 3 product reviews. Fine snowblower, no complaints
Thank you very Much!!!!!!
5