Chute Directional Control
The chute directional control is located on left side of
the snow thrower.
Primer
Choke
To change the direction in which snow is thrown, turn
chute directional control as follows:
•
•
Crank clockwise to discharge to the left.
Crank counterclockwise to discharge to the right.
Chute Tilt Control
The distance snow is thrown can be adjusted by
adjusting the angle of the chute assembly. Move the
chute tilt control forward to decrease the distance,
toward the rear to increase.
Rope
Starter
Handle
Ignition Key
Throttle
Control
Fuel Shut-off Valve
The fuel shut-off valve, located
Figure 8
Closed
Safety Ignition Key
under fuel tank, controls fuel flow
Open
from the tank. Always make certain
it is in the Open (vertical) position
before attempting to start the engine.
The safety ignition key must be fully inserted in the
switch before the unit will start. Remove the ignition key
when snow thrower is not in use.
Throttle Control
IMPORTANT: Do NOT attempt to turn the key.
The throttle control is located on the engine. It regulates
the speed of the engine.
SECTION5: OPERATINGYOURSNOWTHROWER
Gas And Oil Fill-up
are not certain. If your house wiring system is not a
three-wire grounded system, do not use this
electric starter under any conditions. If your system
is grounded and a three-hole receptacle is not
available at the point your starter will normally be
used, one should be installed by a licensed
electrician.
IMPORTANT: Although your snow thrower comes
shipped with oil already in the engine, you MUST check
the engine oil level as instructed in the separate engine
manual packed with your unit BEFORE starting the
engine for the first time. Read instructions carefully
Service the engine with gasoline and oil as
instructed in the separate engine manual packed with
your snow thrower. Read instructions carefully.
When connecting the power cord, always connect cord
to starter on engine first, then plug the other end into a
three-hole grounded receptacle.
When disconnecting the power cord, always unplug the
end from the three-hole grounded receptacle first.
WARNING: Never fill fuel tank indoors,
with engine running or while engine is
hot. Do not smoke when filling fuel tank.
To Start Engine
Electric Starter
IMPORTANT: If unit shows any sign of motion (traction
or augers) with the controls disengaged, shut engine off
immediately. Readjust as instructed under the heading
Final Adjustments in Section 3 of this manual.
WARNING:
The
electric
starter
is
equipped with a three-wire power cord
and plug, and is designed to operate on
volt AC household current. It must be properly
grounded at all times to avoid the possibility of
electric shock which may be injurious to the
120
•
•
Attach spark plug wire to spark plug.
Make certain the fuel shut-off valve is in the open
(vertical) position.
operator.
Determine that your house wiring is a three-wire
grounded system. Ask a licensed electrician if you
Follow
all
instructions
carefully.
•
Make certain that both the auger control and the
traction control are in the disengaged (released)
position.
8
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals |
|---|---|
| Tags | MTD 550, MTD H623D, MTD H633E, MTD Snow Blower Manual, MTD Snow Boss 750, White Outdoor H623D, White Outdoor H633E, White Outdoor Snow Boss 550, White Outdoor Snow Boss 750 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)