Figure 29
1.
0.030 inch (0.76 mm)
5.
Install the spark plug by hand and then torque it to
15 ft-lb (20.4 N-m).
Note: If you do not have a torque wrench, tighten
the plug firmly.
Figure 28
Adjusting the Traction Drive
Belt
Important: Do not excessively oil the
snowthrower; extra oil may enter the traction
drive and cause the traction drive belt to slip.
Service Interval: After the first hour
Before each use or daily
5.
Wipe up any excess oil.
Adjust the traction drive belt after the first operating
hour, after every 5 operating hours thereafter, and
when the speed selector lever shifts properly but the
snowthrower does not drive in the forward or reverse
speeds.
6.
Grease the snowthrower as shown in Figure 28.
Wipe up any excess grease.
7.
8.
Install the bottom cover.
9.
Return the snowthrower to its upright position.
Connect the wire to the spark plug.
1.
2.
3.
Check and adjust the traction drive as described in
Installing the Traction Rod.
10.
If the problem persists after adjusting the linkage,
contact an Authorized Service Dealer.
Inspecting and Replacing the
Spark Plug
Connect the wire to the spark plug.
Service Interval: Every 100 hours
Replacing the Traction Drive
Belt
Use a Champion RN4C or equivalent spark plug.
Check and gap the spark yearly, and replace the plug
if necessary.
If the traction drive belt becomes worn, oil-soaked, or
otherwise damaged, replace the belt.
1.
2.
3.
Clean around the base of the spark plug.
Remove the spark plug.
1.
2.
Drain gasoline from the fuel tank and the oil from
the crankcase. Refer to Emptying the Fuel Tank and
to Changing the Engine Oil.
Examine the spark plug and replace it if it is cracked,
fouled, dirty, or if the electrodes are worn.
Remove the 2 flange-head bolts that hold the belt
cover in place and set the cover aside (Figure 30).
Important: Do not clean the electrodes because
grit could enter the cylinder and damage the
engine.
4.
Set the gap between the electrodes on the spark plug
at 0.030 inch (0.76 mm) (Figure 29).
20
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 38606, Toro 38607, Toro 622R, Toro Power Max 622E |
| Model Number | 38606, 38607 |
| Model Year | 2007 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English, Polski, Slovenčina, Svenska |
| Serial Number | 270000001 - 270999999 |
| Product Name | Toro 622R Power Throw Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | Snowthrower, Two Stage Small Frame |
| Swath | 22 inch |
| Discharge | Two Stage |
| Engine Manufacturer | Tecumseh |
| Engine Oil Type | 21 oz. (.62l) 5w-30 or 10w / API SH or higher |
| Gearbox Lubricant | Fwd. .9 / 1.3 / 1.9 Rev. 1.3 mph |
| Engine Motor Model # | OH195SA-72566G |
| Engine Motor Size | 195cc |
| Engine Motor Type | 4 Cycle CARB2 |
| Transmission Speed | 3 Forward/1 Reverse |
| Transmission Type | Friction Disc |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)