3
A
B
Setting Up
Your Snow
Thrower
Drive
Auger
A
Figure 3-11
•
Loosen the Nylock nut on the drive control cable and
B
unthread the cable one full turn. See Figure 3-13.
•
•
Recheck adjustment.
A - For models with steel panels.
B - For models with plastic panels.
Retighten the Nylock nut to secure the cable when
correct adjustment is reached.
NOTE: For more details, refer to Drive Control Adjust-
Figure 3-12
ment in the Adjustment Section of this manual.
Auger Control
Check the adjustment of the auger control as follows:
WARNING
Never use your hands
to clean snow and
ice from the chute
assembly or auger
housing.
•
When the auger control is released and in the
disengaged “up” position (see Figure 3-11B), the cable
should have very little slack, but should NOT be tight.
See Figure 3-12.
WARNING:Do not over-tighten the
cable. Over-tightening may prevent the
auger from disengaging and compro-
mise the safety of the snow thrower.
•
•
•
In a well-ventilated area, start the snow thrower engine
as instructed on page 12.
Figure 3-13
While standing in the operator’s position (behind the
snow thrower) engage the auger.
•
Repeat auger control test to verify for proper
adjustment. Repeat previous steps to adjust more, if
necessary.
IMPORTANT
If the tire pressure is not
equal in both tires, the unit
may not travel in a straight
path and the shave plate
may wear unevenly.
Allow the auger to remain engaged for approximately
ten seconds before releasing the auger control.
Repeat this several times.
Skid Shoes
Position the skid shoes based on surface conditions.
Adjust upward for hard-packed snow. Adjust downward
when operating on gravel or crushed rock surfaces. See
“Making Adjustment” Section.
•
•
With the auger control lever in the disengaged “up”
position, walk to the front of the machine.
Confirm that the auger has completely stopped
rotating and shows no signs of motion.
Tire Pressure (PneumaticTires)
IMPORTANT: If the auger shows any signs of rotating,
immediately return to the operator’s position and shut
off the engine. Wait for all moving parts to stop before
readjusting the auger control cable.
The tires are over-inflated for shipping purposes.
Check the tire pressure before operating the snow
thrower. Refer to the tire side wall for tire manufacturer’s
recommended psi and deflate (or inflate) the tires as
necessary.
•
To readjust the control cable, unhook the spring (found
on the end of the auger cable) from the auger actuator
bracket. See Figure 3-12.
•
•
Push the cable coupler through the end of the spring
to expose the lock nut. See Figure 3-13.
Thread the Nylock nut outward (down the coupler)
three full turns to provide more slack in the cable and
reattach the spring to the bracket.
9
| Categories | Columbia Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Columbia 769-04101, MTD 769-04101, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)