ASSEMBLY INSTRUCTIONS
NOTE: Before setting up your cultivator / edger, disconnect
ADJUSTING TINE DEPTH
To adjust the wheel support bracket proceed as follows:
the spark plug wire from the spark plug.
POSITIONING THE HANDLEBARS
1.
2.
3.
4.
Stop engine and disconnect spark plug to avoid accidental
starting.
Remove cotter pin from the clevis pin and slide clevis pin
out of tailpiece bracket (Fig. 3).
Slide the wheel support bracket up or down in the tailpiece,
aligning the holes to the desire height.
Place the clevis pin through the hole and secure with cotter
pin.
1.
Loosen the two knobs on the inside of the handlebars (Fig.
1).
2.
With the unit upright, swing the handlebars up into the
operating position (Fig. 1).
NOTE: Take care not to pinch the throttle cable or switch
wires when positioning the handlebar.
3.
Tighten the knobs to secure the handlebars in place.
NOTE: Do not over-tighten the knobs.
4.
Reconnect the spark plug wire to the spark plug.
Clevis Pin
Cotter Pin
Wheel
Support
Bracket
Tailpiece Bracket
Fig. 3
ATTACHING THE EDGER WHEEL AND BLADE
To convert the cultivator to an edger proceed as follows:
1.
Push the On/Off switch to Off (O) position to stop engine and
tines and disconnect spark plug to avoid accidental starting.
NOTE: It may be necessary to lay the cultivator / edger back in
a horizontal position on a flat level surface with the
upper handle touching the ground.
2.
Remove the click pin from each end of the tine shaft and
slide the tines off the shaft.
3.
Slide the edger wheel, with the hub facing inward, onto the
right side of the tine shaft and secure with the click pin in
the inside hole (Fig. 4).
Edger Guide
Line
Fig. 1
Hub
Handlebars
Edger Wheel
Tine Shaft
Edger Blade
Click Pin
Bolt
Handlebar
Knob
Hole
Fig. 4
Washer
Fig. 2
4.
5.
Slide the edger blade with the hub facing out onto the left
side of tine shaft and secure with the click pin in the inside
hole (Fig. 4).
The edger guide line indicates where cutting will occur.
Guide the unit along a flowerbed, sidewalk, or driveway so
the edger guide line is above the desired line of cut.
5
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD TB144, Troy-Bilt TB144 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)