spark-plug wire, and keep the wire away from the plug
to prevent someone from accidentally starting the
engine. Disconnect the cable on electric motors.
•
Run the machine a few minutes after throwing snow to
prevent freeze-up of the collector (auger)/impeller.
(With the engine running, pull the recoil starter handle
several times.)
•
•
Do not run the engine indoors, except when starting it
and for moving the snowthrower in or out of the
building. Open the outside doors; exhaust fumes are
dangerous.
Toro Snowthrower Safety
The following list contains safety information specific to
Toro products or other safety information that you must
know that is not included in the ANSI or ISO standards.
Do not clear snow across the face of slopes. Exercise
extreme caution when changing direction on slopes.
Do not attempt to clear steep slopes.
•
The rotating impeller/auger or rotor blades can cut
off or injure fingers or hands. Stay behind the
handles and away from the discharge opening while
operating the snowthrower. Keep your face hands,
feet, and any other part of your body or clothing
away from concealed, moving, or rotating parts.
•
•
Never operate the snowthrower without proper guards.
plates or other safety protective devices in place.
Never operate the snowthrower near glass enclosures,
automobiles, window wells, drop-offs, etc. without
proper adjustment of the snow discharge angle. Keep
children and pets away.
•
Before adjusting, cleaning, repairing, and inspecting
the snowthrower, and before unclogging the discharge
chute, stop the engine, remove the key, and wait for
all moving parts to stop. Also, pull the wire off of
the spark plug and keep it away from the plug to
prevent someone from accidentally starting the engine.
•
•
Do not overload the machine capacity by attempting to
clear snow at too fast a rate.
Never operate the machine at high transport speeds on
slippery surfaces. Look behind and use care when
moving in reverse.
•
•
Use a stick, not your hands to remove obstructions
from the discharge chute.
•
•
Never direct discharge at bystanders or allow anyone
in front of the unit.
Before leaving the operator’s position behind the
handles, stop the engine, remove the key, and wait for
all moving parts to stop.
Disengage power to the collector/impeller
(auger/impeller or rotor blades) when snowthrower is
transported or not in use.
•
•
Do not wear loose fitting clothing that could possibly
get caught in moving parts.
•
•
Use only attachments and accessories approved by the
manufacturer of snowthrower (Toro), such as wheel
weights, counterweights, cabs, etc. (Refer to your
Authorized Service Dealer for accessories available for
your snowthrower.)
If a shield, safely device, or decal is damaged,
illegible, or lost, repair or replace it before beginning
operation. Also, tighten any loose fasteners.
•
•
Do not smoke while handling gasoline.
Never operate the snowthrower without good visibility
or light. Always be sure of your footing, and keep a
firm hold on the handles. Walk; never run.
For two-stage snowthrowers, use the lower gear and, if
applicable, the rear wheel position when operating on
slopes.
Maintenance and storage
•
•
Do not use the snowthrower on a roof.
•
Check all fasteners at frequent intervals for proper
tightness to be sure the equipment is in safe working
condition.
Do not touch the engine while it is running or soon
after it is stopped because the engine will be hot
enough to cause a burn. Do not add oil or check the
oil level in the crankcase when the engine is running.
•
Never store the machine with fuel in the fuel tank
inside a building where ignition sources are present
such as hot water and space heaters, clothes dryers,
etc. Allow the engine to cool before storing in any
enclosure.
•
•
Perform only those maintenance instructions described
in this manual. Before performing any maintenance,
service, or adjustment, stop the engine, remove the key
and pull the wire from the spark plug, keeping it away
from the plug to prevent someone from accidentally
starting the engine. If major repairs are ever needed,
contact your Authorized Toro Service Dealer.
•
•
Always refer to this operator’s manual for important
details if the snowthrower is to be stored for an
extended period.
Do not over speed the engine by changing the
governor settings.
Maintain or replace safety and instruction labels, as
necessary.
4
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 38440, Toro CCR 3650 |
| Model Number | 38445 |
| Model Year | 2000 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 200000001 - 200012327 |
| Product Name | Toro CCR 3650 Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | CCR 2000/3000/3600, Snowthrower |
| Swath | 20 inch |
| Discharge | Single Stage |
| Engine Manufacturer | Toro |
| Engine Oil Type | Toro 2 cycle / NMMA-TCW3 |
| Engine Motor Model # | R-tek |
| Engine Motor Size | 6.5 hp |
| Engine Motor Type | 2 Cycle EPA1 |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)