Poulan 1950 2025 2050 2075 2150 2175 2350 2375 LE Series Chainsaw Owners Manual

manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
FUELING & LUBRICATION
To stop  the  engine  move  the ON/STOP
switch to the STOP position.
To start the engine  hold the saw firmly  on
the  ground as  illustrated.    Make  sure the
chain is free  to turn without  contacting  any
object.
Use only 15”--18” of rope per pull.
Hold saw firmly while pulling  starter rope.
WARNING:   Remove fuel cap slow-
ly when refueling.
FUELING ENGINE
This  engine  is certified  to  operate  on un-
leaded gasoline. Before  operation, gasoline
must be mixed with a good quality synthetic
Starter rope handle
2-cycle
air-cooled engine oil designed  to be
mixed at a ratio of 40:1. Poulan/Weed Eater
brand synthetic oil is recommended. (A 40:1
ratio is obtained by mixing  3.2 ounces of oil
with 1 gallon of unleaded gasoline). DO NOT
USE automotive  or boat oil.  These oils  will
cause engine damage. When mixing fuel fol-
low the instructions printed on the container.
Always read and follow the safety rules listed
under HANDLE FUEL WITH CAUTION.
Left hand
on front
handle
Right foot through rear handle
IMPORTANTPOINTS TOREMEMBER
When pulling the starter rope, do not use the
full extent  of the rope as this can cause the
rope to break.  Do  not let starter rope  snap
back.  Hold  the handle and  let the rope re-
wind slowly.
BAR AND CHAIN LUBRICATION
The bar and chain  require continuous lubri-
cation.  Lubrication  is provided by the auto-
matic oiler system  when the oil tank is kept
filled. Lack of oil will quickly ruin the bar and
chain.  Too  little  oil will  cause  overheating
shown by smoke coming from the chain and/
or discoloration of the bar.
NOTE:  Do not attempt to cut material with
the fast idle lock button in the locked position.
In freezing weather oil will thicken, making it
necessary  to thin  bar and  chain oil  with a
small amount (5 to 10%) of #1 Diesel Fuel or
STARTING  A   COLD   ENGINE  (or
warm  engine  after running  out  of
fuel)
kerosene.
Bar and  chain oil  must be  free
ON/STOP SWITCH
flowing for the oil system to pump enough oil
for adequate lubrication.
(SIDE VIEW)
Genuine PoulanRbarand  chain oil is recom-
mended to protect  your unit against  exces-
sive wear from  heat and friction.   PoulanR
oil resists high temperature thinning.  If Pou-
lanR  bar and chain oil is not available, use a
good grade SAE 30 oil.
ON
STOP
S  Move ON/STOP switch to the ONposition.
S
Pull choke knob out to the  full extent.
S  Slowly press primer bulb 6 times.
S  Never use waste oil for bar and chain lubri-
cation.
S  Always stop the  engine before  removing
the oil cap.
S
Squeeze  and  hold  throttle  trigger.  With
thumb press fast  idle lock down; then  re-
lease throttle trigger.
IMPORTANT
Experience  indicates  that alcohol--blended
fuels  (called  gasohol  or  using  ethanol  or
methanol) can attract  moisture which leads
to separation  and formation of  acids during
Fast idle lock button
Throttle
lock--out
storage.
Acidic  gas can  damage  the fuel
To
system  of an  engine while  in storage.
Choke knob
Throttle
avoid  engine   problems,  the   fuel  system
should  be  emptied  before  storage  for  30
days or longer. Drain the gas tank,  start the
engine and  let it run until  the fuel  lines and
carburetor are  empty.   Use fresh fuel  next
trigger
S  Sharply pull the starter rope handle 5times
with your right hand.
season.
See STORAGE  section  for addi-
S  Push the choke knob in completely (to the
OFF position); pull the starter rope until the
engine starts.
tional information.
CHOKE
STARTING
(SIDE VIEW)
WARNING:
The chain  must  not
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
Choke knob
OFF
FULL
BURETOR
ADJUSTMENT
within
this
8
Product Specification
CategoriesChainsaw Manuals, Poulan Chainsaw Manuals
Tags, , , , , , , ,
Model Year2001
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 16 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandPoulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw
Document File TypePDF
Publisherpoulan.com
Wikipedia's PagePoulan
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website