FUELING & LUBRICATION
STARTING
WARNING:
The chain must not
WARNING: Remove fuel cap slow-
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
ly when refueling.
FUELING ENGINE
BURETOR
ADJUSTMENT
within
this
This
engine
is certified to operate on
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
unleaded
gasoline.
Before
operation,
gasoline must be mixed with a good quality
To stop the engine move the ON/STOP
2-cycle
air-cooled
engine
oil.
We
switch to the STOP position.
recommend Poulan/Weed Eater brand oil. If
you do not use this oil, use a good quality
To start the engine hold the saw firmly on
the ground as illustrated. Make sure the
chain is free to turn without contacting any
object.
2-cycle
air-cooled oil designed to be mixed at
a ratio of 40:1. A 40:1 ratio is obtained by
mixing 3.2 onces of oil with 1 gallon of
unleaded gasoline. Included with this saw is
a 3.2 ounce container of Poulan/Weed Eater
brand oil. Pour the entire contents of this
container into 1 gallon of gasoline to achieve
the proper fuel mixture.
DO NOT USE automotive or boat oil. These
oils will cause engine damage. When mixing
fuel follow the instructions printed on the
container. Always read and follow the safety
rules listed under HANDLE FUEL WITH
CAUTION.
Use only 15”---18” of rope per pull.
Hold saw firmly while pulling starter rope
Starter rope handle
Left hand
on front
handle
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubri-
cation. Lubrication is provided by the auto-
matic oiler system when the oil tank is kept
filled. Lack of oil will quickly ruin the bar and
chain. Too little oil will cause overheating
shown by smoke coming from the chain and/
or discoloration of the bar.
Right foot through rear handle
IMPORTANTPOINTS TOREMEMBER
When pulling the starter rope, do not use the
full extent of the rope as this can cause the
rope to break. Do not let starter rope snap
back. Hold the handle and let the rope rewind
slowly.
In freezing weather oil will thicken, making it
necessary to thin bar and chain oil with a
small amount (5 to 10%) of #1 Diesel Fuel or
For cold weather starting, start the unit at
FULL CHOKE; allow the engine to warm up
before squeezing the throttle trigger.
kerosene.
Bar and chain oil must be free
flowing for the oil system to pump enough oil
for adequate lubrication.
NOTE:
Do not cut material with the choke/
fast idle lever at the FULL CHOKE position.
Genuine Poulan or Poulan PROR bar and
chain oil is recommended to protect your unit
against excessive wear from heat and
friction. Poulan or Poulan PROR oil resists
high temperature thinning. If Poulan or
STARTING A COLD ENGINE (or
warm engine after running out of
fuel):
NOTE: In the following steps, when the
choke/fast idle lever is pulled out to the full
extent, the correct throttle setting for starting
is set automatically.
Poulan PROR
bar and chain oil is not
available, use a good grade SAE 30 oil.
S Never use waste oil for bar and chain lubri-
cation.
Move ON/STOP switch to the ONposition.
S
S Always stop the engine before removing
S Pull out choke/fast idle to the full extent.
the oil cap.
Slowly press primer bulb 6 times.
Pull the starter rope quickly with your right
hand 5 times. Then, proceed to the next
step.
S
S
IMPORTANT
Experience indicates that alcohol--blended
fuels (called gasohol or using ethanol or
methanol) can attract moisture which leads
to separation and formation of acids during
NOTE: If the engine sounds as if it is trying
to start before the 5th pull, stop pulling and
immediately proceed to the next step.
storage.
Acidic gas can damage the fuel
To
system of an engine while in storage.
S Push the choke/fast idle lever in complete-
ly (to the OFF position).
avoid engine problems, the fuel system
should be emptied before storage for 30
days or longer. Drain the gas tank, start the
engine and let it run until the fuel lines and
carburetor are empty. Use fresh fuel next
S Pull the starter rope quickly with your right
hand until the engine starts.
S Allow the engine to run for approximately 5
seconds.
Then, squeeze and release
season.
See STORAGE section for addi-
throttle trigger to allow engine to return to
idle speed.
tional information.
9
| Categories | Chainsaw Manuals, Poulan Chainsaw Manuals |
|---|---|
| Tags | Poulan 220, Poulan 260 |
| Model Year | 2001 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw |
| Document File Type | |
| Publisher | poulan.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)