MAINTENANCE
Maintenance
The maintenance described in this section refers
to measures that can be carried out by the user.
If faults are detected that cannot be rectified in
accordance with this operator’s manual, contact
your nearest authorised service representative.
Monthly Maintenance
1. Checking the Clutch Function. See page 34.
2. Clean the inside of the bandsaw’s cleaning
fluid tank.
3. Check cables and connections.
4.
Check that the saw carriage runs easily and
that no binding is felt which can indicate
bearing damage. Replace the wheels if
needed. See page 18.
Daily Maintenance
1.
Check that nuts and screws are tight.
2.
Height adjustment mechanism:
Clean both the screws and the guides. See
page 34.
5. Adjust the play on the bearings that run
against the underside of the rails. See page
18.
3.
4.
Adjust the bandsaw blade tension. See page
21.
6. Check the bolted joints on the rail sections.
See page 16.
Check that the bandsaw blade’s cleaning
system works. If the cleaning fluid is depleted
on an ongoing basis, then the cleaning
system works.
7. Check that the rails rest against all contact
points on the wooden beams.
5.
6.
Clean any sawdust from the bandsaw blade
guides.
Storage
Check that all safety devices are undamaged
and work. Check:
If the one-man sawmill needs to be stored for a
long period without being used the following
applies:
•
•
•
•
•
•
•
•
Start/stop devices
Electrical contacts
1.
2.
Empty and clean the fuel tank.
Band wheel guards
Safety switch for the band guards
Rail stop
Empty and clean the bandsaw’s cleaning
fluid tank.
3.
4.
Remove the bandsaw blade.
Rail guards
Spray preservative oil in the spark plug hole
and carburettor while turning the engine over
with the starter handle.
Belt guard
Electrical cables and electrical connections
7.
Set and sharpen the bandsaw blade as
required. When cutting timber with a normal
sand content and hardness, these actions
should be carried out after about 1 hour of
sawing (time for adjustments, timber hand-
ling, etc are not included). See pages 30-32.
5.
Remove the saw carriage and unbolt the rail
sections.
6.
7.
Oil all parts.
Store the one-man saw in a dry location.
8. After a period of one year the following
measures apply:
•
hole and carburettor while turning the engine
over with the starter handle.
Spray preservative oil in the spark plug
Weekly Maintenance
1.
Petrol Engine Maintenance (see the engine
manual).
•
Oil all parts.
2.
3.
Clean the bandsaw blade scrapers.
Clean the height adjustment screws, guides,
and chain. See page 34.
4.
5.
Check the belt tension and adjust if required.
See page 33.
Clean around the rails. Remove sawdust,
bark, and wood chips to facilitate handling of
the one-man saw.
English –
35
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 70E, Husqvarna SMB70 |
| Model Year | 2003, 2004 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)