ASSEMBLY
Protective gloves (not provided) should be
6. Prepare the chain by checking the proper
direction. Without followingthe illustration it
is easy to placethechain on thesaw in the
wrong direction. Use the illustration of the
chain to determine the proper direction.
worn during assembly.
ATTACHING THE BAR & CHAIN (If
not already attached)
WARNING: Recheck each assem-
bly stepif thesaw isreceived assembled.Al-
ways wear gloves when handling the chain.
The chain is sharp and can cut you even
when it is not moving!
Tip of
Bar
1.
Loosen and remove the clamp nuts and
the bar clamp from the saw.
Remove the plastic shipping spacer (if
present).
2.
CUTTERS MUST FACE IN
DIIRECTION OF ROTATION
Location of shipping spacer
Cutters
Depth Gauge
Bar Clamp/
Chain Brake
Drive Links
Bar Clamp Nuts
Bar Tool
7.
Place chain over and behind clutch, fit-
ting the drive links in the clutch drum
sprocket.
3.
An adjustingpin andscrew is used toad-
just the tension of the chain. It is very im-
portant when assembling the bar, that
the pin located on the adjusting screw
aligns into a hole in the bar. Turning the
screw will move the adjustment pin up
and down the screw. Locate this adjust-
ment before you begin mounting the bar
onto the saw. See illustration.
Place chain onto the sprocket
8.
9.
Fit bottom of drive links between the
teeth in the sprocket in the nose of the
guide bar.
Fit chain drive links into bar groove.
Inside view of
Chain Brake
10. Pull guide bar forwarduntil chain is snug
in guide bar groove. Ensure all drive
links are in the bar groove.
11
Now, install chain brake making surethe
adjusting pin is positioned in the lower
hole in the guidebar. Rememberthis pin
moves the bar forwardand backward as
the screw is turned.
Install chainbrakenutsandfingertighten
only. Once the chain is tensioned, you
will need to tighten chain brake nuts.
Adjustment located on Bar Clamp
4.
5.
Turn the adjusting screw counterclock-
wise to move the adjusting pin almost as
far as it will go to the rear. This should al-
low the pin to be near the correct posi-
tion. Further adjustment may be neces-
sary as you mount the bar.
Slide guide bar behind clutch drum until
guide bar stops against clutch drum
sprocket.
12.
CHAIN TENSION (Including units with
chain already installed)
NOTE:
When adjusting chain tension,
make sure the bar nuts are finger tight only.
Attemptingto tension the chain when thebar
nuts are tight can cause damage.
Checking the tension:
Use the screwdriver end of the combination
screwdriver/wrench tool to move the chain
aroundthe bar. If thechain does not rotate,it
is tootight.Iftooloose, the chain will sag be-
low the bar.
Mount the Bar
7
| Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
|---|---|
| Tags | Husqvarna 136, Husqvarna 136LE, Husqvarna 141, Husqvarna 141LE |
| Model Year | 2003, 2004, 2005, 2006 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Husqvarna, Chainsaw |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)