SAFETY INSTRUCTIONS
Lubricating the bar tip sprocket
Chain drive sprocket
Lubricate the bar tip sprocket each time you refuel. Use the
special grease gun and a good quality bearing grease.
The clutch drum is fitted with one of the following drive
sprockets:
A Spur sprocket (the chain sprocket is welded on the drum)
B Rim sprocket (replaceable)
Needle bearing lubrication
Regularly check the degree of wear on the drive sprocket.
Replace if wear is excessive. Replace the drive sprocket
whenever you replace the chain.
The clutch drum is fitted with one of the following drive
sprockets:
Bar
A Spur sprocket (the chain sprocket is welded on the drum)
B Rim sprocket (replaceable)
Check regularly:
•
Whether there are burrs on the edges of the bar. Remove
these with a file if necessary.
Both versions have a needle bearing on the drive shaft, which
has to be greased regularly (once a week). CAUTION! Use a
high-quality bearing grease or engine oil.
•
•
Whether the groove in the bar has become badly worn.
Replace the bar if necessary.
Checking wear on cutting equipment
Whether the tip of the bar is uneven or badly worn. If a
hollow forms on the underside of the bar tip this is due to
running with a slack chain.
Check the chain daily for:
•
•
•
Visible cracks in rivets and links.
Whether the chain is stiff.
•
To prolong the life of the bar you should turn it over daily.
Whether rivets and links are badly worn.
We recommend you compare the existing chain with a new
chain to decide how badly the existing chain is worn.
When the length of the cutting teeth has worn down to only 4
mm the chain must be replaced.
14
– English
Categories | Chainsaw Manuals, Husqvarna Chainsaw Manuals |
---|---|
Tags | Husqvarna 362XP, Husqvarna 365, Husqvarna 372XP |
Model Year | 2004 |
Download File |
|
Document Type | Operator's Manual |
Language | English |
Product Brand | Husqvarna, Chainsaw |
Document File Type | |
Publisher | husqvarna.com |
Wikipedia's Page | Husqvarna |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)