Balancing the Blade
Emptying the Fuel Tank
1.
Check the balance of the blade by placing the center
hole of the blade over a nail or screwdriver shank
clamped horizontally in a vise (Fig. 17).
1.
Stop the engine and wait for it to cool.
Important
Drain gasoline from a cold engine only.
2.
3.
4.
Disconnect the wire from the spark plug (Fig. 7).
Remove the cap from the fuel tank (Fig. 5).
Use a hand pump to pump the gasoline into a clean
approved gasoline container.
1007
Figure 17
5. Connect the wire to the spark plug.
6.
7.
Run the engine until it stops.
Note: You can also check the balance using a commercially
manufactured blade balancer.
Start the engine again to ensure that all the gasoline is
out of the carburetor.
2.
If either end of the blade rotates downward, file that end
(not the cutting edge or the end near the cutting edge).
The blade is properly balanced when neither end drops.
Folding the Handle
Warning
Installing the Blade
1.
Install a sharp, balanced Toro blade, the accelerator, and
the blade bolt (Fig. 15).
Folding or unfolding the handle improperly can
pinch, stretch, or damage one or more of the
cables. Any pinched, stretched, or damaged cable
may cause an operational failure that results in an
unsafe operating condition.
Note: The sail part of the blade must point upward
(toward the top of the housing).
2.
Torque the blade bolt to 60 ft-lb (82 Nm).
•
•
Do not pinch, stretch, or damage the cables.
Handle the cables with care when folding or
unfolding the handle.
Warning
•
Do not use the lawn mower if one or more of the
cables are pinched, stretched, or damaged.
Contact an Authorized Service Dealer.
Operating the lawn mower without the accelerator
in place can cause the blade to flex, bend, or break,
resulting in serious injury or death to the operator
or bystanders.
Important
Do not remove or loosen the knobs that
secure the the lower handle to the swing bracket. Do not
fold the upper handle backward.
Do not operate the lawn mower without the
accelerator.
1.
2.
Loosen the knobs that secure the upper handle section.
3.
4.
Return the lawn mower to its upright position.
Connect the wire to the spark plug.
Carefully swing the upper handle section forward until
it rests on the engine (Fig. 18).
Cleaning the Cooling System
After every 100 operating hours or every season, clean the
dirt and the chaff from the cylinder, the cylinder head fins,
and around the carburetor and the linkage. Remove debris
from the air intake slots on the recoil housing. This will
ensure proper cooling and the best engine performance.
m-4217a
Figure 18
15
| Categories | Lawn Mower Manual, Toro Lawn Mower Manual |
|---|---|
| Tags | Toro 20033 |
| Model Number | 20033 |
| Model Year | 2004 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 240000001-240999999 |
| Product Name | Super Recycler Mower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Product Type | Walk Behind Mower |
| Product Series | Toro 21" (53cm) 3 in 1 / Recycler |
| Swath | 21 inch |
| Discharge | Recycler |
| Engine Manufacturer | Briggs & Stratton |
| Engine Oil Type | 20 oz. (.6l) 30w or 10w-30 / API SH or higher |
| Engine Motor Model # | 123K02-0114-E1 |
| Engine Motor Size | 6.5 hp |
| Engine Motor Type | 4 Cycle CARB1 |
| Transmission Type | Hand Push |
| Spark Plug | Champion RJ19LM |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Lawn and Garden readers have rated Toro 20033 21-Inch Super Recycler Lawn Mower Operators Manual, 2004 3.0 out of 3.0 based on 1 product reviews. Good website