Poulan BH 2160 Chainsaw Owners Manual

FUELING & LUBRICATION
STARTING
WARNING:
The  chain must  not
WARNING: Removefuelcapslowly
move when the engine runs at idle speed. If
the chain moves at idle speed refer to CAR-
when refueling.
FUELING ENGINE
BURETOR
ADJUSTMENT
within
this
This engine  is  certified to  operate on  un-
leaded gasoline. Before operation, gasoline
must be mixed with a good quality synthetic
manual. Avoid contact with the muffler. A hot
muffler can cause serious burns.
To stop  the engine  move the  ON/STOP
switch to the STOP position.
2-cycle
air-cooled engine oil designed to be
mixed at a ratio of 40:1. Poulan/Weed Eater
brand  synthetic  oil is  recommended.  Mix
gasolineandoilataratioof40:1.     A 40:1ratio
is obtainedby mixing3.2ounces  (95ml) ofoil
with 1 gallon (4 liters) of  unleaded gasoline.
Includedwiththissawis   a3.2ouncecontain-
er of oil. Pour theentire contents of this con-
tainer into 1 gallon of gasoline to achievethe
proper fuel mixture.
DO NOT USE automotiveoilor boat oil.These
oils will cause  engine damage. When mixing
fuel, follow  instructions  printed on container.
Once oil is added to gasoline, shake container
momentarily toassurethatthefuelisthorough-
ly mixed.  Always read and  follow the safety
rules relating to fuel before fueling your unit.
To start the engine hold the saw firmly on
the ground  as illustrated.    Make sure  the
chain is free to turn without  contacting any
object.
Use only 15”--18” of rope per pull.
Hold saw firmly while pulling starter rope.
Starter rope handle
Left hand
on front
handle
Right foot through rear handle
BAR AND CHAIN LUBRICATION
The bar and chain require continuous lubri-
cation.  Lubrication is provided by the auto-
matic oiler system when the oil tank is kept
filled. Lack of oil will quickly ruin the bar and
chain.  Too little  oil will  cause overheating
shownby smokecomingfromthechainand/
or discoloration of the bar.
IMPORTANTPOINTS TOREMEMBER
When pulling the starter rope, do not use the
full extent of the rope as this can cause the
rope to break.  Do not let starter rope snap
back.  Hold the handle and let  the rope re-
wind slowly.
NOTE:  Do not attempt to cut material with
thefastidlelockbuttoninthelockedposition.
In freezing weather oil will thicken, making it
necessary to  thin bar and  chain oil with  a
small amount (5 to 10%) of #1 Diesel Fuel or
STARTING  A   COLD  ENGINE   (or
warm  engine after  running  out of
kerosene.
Bar and  chain oil must be  free
fuel)
flowing for the oil system to pump enough oil
for adequate lubrication.
ON/STOP SWITCH
(SIDE VIEW)
GenuinePoulanRbarandchainoilisrecom-
mended to protect your unit against exces-
sive wear from heat and friction.   PoulanR
oil resists high temperature thinning. If Pou-
lanR  bar andchainoilis  notavailable,usea
good grade SAE 30 oil.
ON
STOP
S  Never usewasteoilfor bar andchainlubri-
1.
Move ON/STOP switch to the ON posi-
tion.
Pull choke knob out to the full extent.
Slowly press primer bulb 6 times.
Squeeze and hold  throttle trigger. With
thumb press fast idle lock down; thenre-
lease throttle trigger.
cation.
S  Always stop the engine before  removing
the oil cap.
2.
3.
4.
IMPORTANT
Experience indicates  that alcohol--blended
fuels  (called gasohol  or  using  ethanol or
methanol) can attract moisture which leads
to separation and formation of acids during
Fast idle lock button
storage.
Acidic gas  can damage  the fuel
Throttle
lock--out
system of  an engine while  in storage.
To
avoid  engine  problems,  the  fuel  system
should  be emptied  before  storage for  30
days or longer. Drain the gas tank, start the
engine and let it run until the fuel  lines and
carburetor are empty.   Use fresh fuel  next
Choke knob
Throttle
trigger
5.
Sharply pull  the  starter rope  handle 5
times  with your right hand.   Then, pro-
ceed to the next step.
season.
See STORAGE  section for addi-
tional information.
9
Product Specification
CategoriesChainsaw Manuals, Poulan Chainsaw Manuals
Tags
Model Year2005
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 18 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandPoulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw
Document File TypePDF
Publisherpoulan.com
Wikipedia's PagePoulan
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website