Toro Snow Commander 38603 Snow Blower Operators Manual, 2005

10
Adjusting the Rotor Control Cable
Adjusting the Traction
Drive Cable
1.
Unhook the spring end from the control bar
bracket (A).
Check the traction drive cable for proper adjustment
initially, after the first operating hour, and then
annually thereafter.
Checking the Traction Drive Cable
D
1.   Squeeze the control
bar against the right side
of the handle.
A
B
C
m-5054
2.
Slide the spring cover (B) up the cable
m-5066
adjuster (C).
2.
Ensure that the
B
3.
Unhook the Z-fitting (D) from the cable adjuster,
distance (A) between
the pivot plate (B) and
the wheel frame (C) is 0
to 1/8 in. (0 to 3 mm).
and position it in a different hole on the adjuster to
obtain a gap of 1/8 to 1/4 inch (3 to 6 mm) between
the control bar bracket and the handle.
A
C
Note: Moving the Z-fitting to a hole closer to the
spring decreases the gap between the control bar
bracket and the handle; moving it to a hole farther
from the spring increases the gap.
m-5056
4.
5.
the control bar bracket.
Install the spring cover over the cable adjuster.
Important: If the pivot plate touches the wheel frame
before the control bar touches the handle, the cable is
too tight.
Hook the spring end into the hole in the center of
6.
Check the adjustment.
Note: After extended use, the drive belt may wear
and lose its proper belt tension. If the drive belt slips
(continuously squeals) under a heavy load, increase
the belt tension by inserting the spring end into the
other hole in the control bar bracket. The belt may slip
in wet conditions; to dry out the drive system, start
the rotor and operate it without a load for 30 seconds.
Adjust the gap between the control bar bracket and
the handle to 1/8 to 1/4 in. (3 to 6 mm).
3327-957
Product Specification
CategoriesSnow Blower Manuals, Toro Snow Blower
Tags,
Model Number38603
Model Year2005
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 12 pages
Document TypeOperator's Manual
LanguageEnglish
Serial Number250000001 - 250999999
Product NameToro Snow Commander Snowthrower
Product BrandToro. Customer Service Representatives are available by phone: Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower
Product TypeSnowthrower
Product SeriesSingle Stage Snow Commander, Snowthrower
Swath24 inch
DischargeSingle Stage
Engine ManufacturerToro
Engine Oil TypeToro 2 cycle / NMMA-TCW3
Engine Motor Model #R-tek
Engine Motor Size141cc
Engine Motor Type2 Cycle EPA2
Document File TypePDF
Publishertoro.com
Wikipedia's PageToro Company
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website