OPERATION
To avoid possible freeze-up of starter, proceed as follows:
ELECTRIC STARTER
WARNING: Do not use the electric
starter if your house is not a 120 Volt
A.C. three-wire grounded system. Se-
riouspersonalinjuryordamagetoyour
snow thrower could result.
1.
Connect the power cord to the engine.
2.
Plug the other end of the power cord into a three-hole
grounded 120 Volt A.C. receptacle.
3.
While the engine is running, push starter button and
spin the starter for several seconds.
COLD START - ELECTRIC STARTER
1.
Insert safety ignition key (packed separately in parts
bag)intoignitionslotuntilitclicks. DONOTturnthekey.
Keep the extra safety ignition key in a safe place.
NOTE: The unusual sound made while starter is spinning
will not harm the engine or starter.
4.
Disconnect the power cord from the receptacle first,
then from the engine.
2.
3.
4.
5.
Place throttle control in FAST position.
Rotate choke control to FULL position.
Connect the power cord to the engine.
RECOIL STARTER
1.
Whiletheengineisrunning,pulltherecoilstarterhandle
with rapid, full arm strokes three or four times.
Plug the other end of the power cord into a three-hole
grounded 120 Volt A.C. receptacle.
NOTE: The unusual sound made while pulling the recoil
starter handle will not harm the engine or starter.
6.
7.
Push the primer three (3) times.
Push starter button until engine starts.
IF RECOIL STARTER HAS FROZEN
If the recoil starter has frozen and will not turn the engine,
proceed as follows:
IMPORTANT: Do not crank engine more than five con-
tinuous seconds between each time you try to start. Wait
5
to 10 seconds between each attempt.
1.
Grasp the recoil starter handle and slowly pull as much
rope out of the starter as possible.
8.
When the engine starts, release the starter button and
slowly move the choke control to the “OFF” position.
2.
Release the recoil starter handle and let it snap back
against the starter.
9.
Disconnect the power cord from the receptacle first,
then from the engine.
If the engine still fails to start, repeat the above steps or
use the electric starter.
Allow the engine to warm up for a few minutes. Engine will
not develop full power until it has reached normal operat-
ing temperature.
SNOW THROWING TIPS
WARM START - ELECTRIC STARTER
Follow the steps above, keeping the choke control in the
OFF position.
•
•
•
•
Always operate the snow thrower with the engine at
full throttle. Full throttle offers the best performance.
Goslowerindeep,freezingorheavywetsnow.Usethe
drive speed control, NOT the throttle, to adjust speed.
COLD START - RECOIL STARTER
1.
Insert safety ignition key (packed separately in parts
bag)intoignitionslotuntilitclicks. DONOTturnthekey.
Keep the extra safety ignition key in a safe place.
It is easier and more efficient to remove snow imme-
diately after it falls.
The best time to remove snow is the early morning. At
this time the snow is usually dry and has not been ex-
posed to the direct sun and warming temperatures.
2.
3.
4.
Place throttle control in FAST position.
Rotate choke control to FULL position.
•
Slightly overlap each successive path to ensure all
snow will be removed.
Push the primer four (4) times if the temperature is
below 15°F, or two (2) times if temperature is between
15°
and 50°F. If temperature is above 50°F, priming is
•
•
Throw snow downwind whenever possible.
not necessary.
Adjust the skid plates to proper height for current snow
conditions. See “TO ADJUST SKID PLATES” in this
section of this manual.
NOTE: Overprimingmaycauseflooding,preventingtheen-
ginefromstarting.Ifyoudofloodtheengine,waitafewmin-
utesbeforeattemptingtostartandDONOTpushtheprimer.
•
•
•
•
Forextremelyheavysnow,reducethewidthofsnowre-
movalbyoverlappingpreviouspathandmovingslowly.
5.
Pull recoil starter handle quickly. Do not allow starter
rope to snap back.
Keep engine clean and clear of snow during use. This
will help air flow and extend engine life.
6.
When the engine starts, release the recoil starter
handle and slowly move the choke control to the OFF
position.
Aftersnow-throwingiscompleted,allowenginetorunfor
a few minutes to melt snow and ice off the engine.
Allow the engine to warm up for a few minutes. Engine will
not develop full power until it has reached normal operating
temperature.
Clean the entire snow thrower thoroughly after each
use and wipe dry so it is ready for next use.
WARM START - RECOIL STARTER
Follow the steps above, keeping the choke in the OFF
position. DO NOT push the primer.
WARNING:
Do not operate snow
throwerifweatherconditionsimpairvis-
ibility. Throwing snow during a heavy,
windy snowstormcanblind youandbe
hazardous to the safe operation of the
snow thrower.
BEFORE STOPPING
Run the engine for a few minutes to help dry off any mois-
ture on the engine.
13
| Categories | Husqvarna Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Husqvarna 10530SBE |
| Model Year | 2006, 2007, 2008 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Husqvarna, Snow Blower |
| Document File Type | |
| Publisher | husqvarna.com |
| Wikipedia's Page | Husqvarna |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)