S
Check bar and chain oil before use
and every 15 minutes while operating
the saw. See GUIDE BAR AND CHAIN
OIL under the OPERATION section.
File Rail Edges
and Sides
Square
Worn Groove
Correct Groove
INSPECT AND CLEAN UNIT AND
LABELS
S
S
Replace the guide bar when the groove
is worn,the guide bar isbentorcracked,
or when excess heating or burring ofthe
rails occurs. If replacement is neces-
sary,use only the guide bar specifiedfor
your saw in the repair parts list or on the
decal located on the chain saw.
LUBRICATION
After each use, inspect complete unit
forloose or damaged parts. Clean the
unitandlabelsusing adamp clothwith
a mild detergent.
Wipe off the unit and labels with a
clean dry cloth.
Bar Oil
Fill Cap
SERVICE AND ADJUSTMENTS
CHAIN SHARPENING
TO REPLACE CHAIN:
Chain
tools.
sharpening
requires
special
1. Disconnect the chain saw from the
power source.
You can purchase sharpening
tools at an authorized service dealer or
go to a professional chain sharpener.
2. Turn the unit upside down on a flat
surface. Straighten out chain, then
lay it on a flat surface.
WARNING: Avoid accidental start-
ing. Always unplug saw from power
source before installing a bar and/or
chain.
CHAIN REPLACEMENT
Adjusting
Screw
WARNING:
Wear
protective
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
Bar Nuts
Itisnormalforanewchaintostretchdur-
ing the first15 minutes of operation.You
should recheck your chain tension fre-
quently and adjust the chain tension as
required. See CHECK CHAIN TENSION
section.
Replace the old chain when it becomes
worn or damaged. Use only the Low
Kickback replacement chain specified
in the listofavailable replacementparts.
Thechainmustcomplywithkickbackre-
quirementsofANSIB175.1 whentested
with this saw.
See an authorized service dealer to re-
place and sharpen individual cutters on
your chain.
3
.
Remove bar mounting nuts, bar
clamp plate, and old chain.
Turn the adjusting screw counter-
clockwise to move the adjusting pin
almost as far as it will go to the rear.
Do not remove the adjusting screw
from the unit.
4.
5. Hold chain with cutters facing as
shown.
Tip of
Bar
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
13
| Categories | Chainsaw Manuals, Poulan Chainsaw Manuals |
|---|---|
| Tags | Poulan 1420, Poulan 1630 |
| Model Year | 2006 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw |
| Document File Type | |
| Publisher | poulan.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)