Poulan PR8527ES 403919 Snow Blower Owners Manual

MAINTENANCE
AUGER GEAR CASE
Oil will drain more freely when warm.
Catch oil in a suitable container.
The gear case  was filled with lubricant  to the proper
level at the factory. The only time the lubricant needs
attention is if service has been performed on the gear
case.
NOTE: The  left side wheel  may be  removed from snow
thrower for easier access  to the oil drain plug and place-
ment of a suitable container.The unit tilted, resting on the
frame with the left  wheel removed, will help drain  any oil
trapped inside the engine. (See “TO REMOVE WHEELS”
in the Service and Adjustments section of this manual).
If  lubricant   is  required,   use   only  Ronex   ED  #1
grease.
TRACTION DRIVE SYSTEM
1.
Disconnect spark plug wire from spark plug and place
wire where it cannot come in contact with plug.
DO NOT lubricate the drive  components inside the snow
thrower. The sprockets, hex shafts, drive disc and friction
wheel require no  lubrication. The bearings and bushings
are lifetime lubricated and require no maintenance.
2.   Clean area around drain plug.
3.
4.
Remove drain plug and drain oil in a suitable container.
Install drain plug and tighten securely.
CAUTION:Anylubricatingoftheabovecompo-
nents can cause contamination of the friction
wheel and damage to the drive system of your
snow thrower.
5.   Wipe off any spilled oil from snow thrower and engine.
6.
Install left wheel (if removed for draining oil).Be sure to
install klick pin into proper hole in wheel axle (See “TO
REMOVE WHEELS” in the Service  and Adjustments
section of this manual).
ENGINE
See engine manual.
7.
8.
Remove oil fill cap/dipstick. Be careful not to allow dirt
to enter the engine.
LUBRICATION
Refill engine  with  oil through  oil dipstick  tube. Pour
slowly. Do not  overfill. For approximate  capacity see
“PRODUCTSPECIFICATIONS”sectionofthismanual.
Use only high quality detergent oil rated  with API service
classification SG–SL. Select the oil's SAE viscosity grade
according to your expected operating temperature.
9.
Use gauge on oil fill cap/dipstick for checking level. Be
sure dipstick  cap  is tightened  securely for  accurate
reading. Keep oil at “FULL” line on dipstick.
10.
Wipe off any spilled oil.
MUFFLER
Inspect and replace corroded muffler as  it could create a
fire hazard and/or damage.
SPARK PLUG
Replacesparkplugatthebeginningofeachseasonorafter
every100hoursofoperation,whicheveroccursfirst.     Spark
plug type  and gap setting  are shown in  the “PRODUCT
SPECIFICATIONS” section of this manual.
NOTE:  Although multi-viscosity oils (5W30, 10W30  etc.)
improve starting in cold weather, these multi-viscosity oils
will result in increased oil consumption when used above
CLEANING
IMPORTANT:  For best performance, keep snow thrower
housing free of any dirt or trash. Clean the outside of your
snow thrower after each use.
32°F.
Check your engine oil level more frequently to avoid
possible engine damage from running low on oil.
Changetheoilafterevery25hoursofoperationoratleastonce
ayearifthesnowthrowerisnotusedfor25hoursinoneyear.
Checkthecrankcaseoillevelbeforestarting    theengineand
after each five (5) hours of  continuous use. Tighten oil fill
cap / dipstick securely each time you check the oil level.
WARNING: Disconnectsparkplugwire
from spark plug and place wire where it
cannot come in contact with plug.
TO CHANGE ENGINE OIL
Keepfinishedsurfaces/wheelsfreeofgasoline,oil,etc.
Determine temperature  range anticipated before next  oil
change.AlloilmustmeetAPIserviceclassificationSG–SL.
We do not recommend using a garden hose  to clean
yoursnowthrowerunlesstheelectrical   system,muffler
and carburetor are covered  to keep water out. Water
in engine can result in shortened engine life.
Be sure snow thrower is on level surface.
14
Product Specification
CategoriesPoulan Snow Blower Manuals, Snow Blower Manuals
Tags
Model Year2006
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
LanguageEnglish
Product BrandPoulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Snow Blower
Document File TypePDF
Publisherpoulan.com
Wikipedia's PagePoulan
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website