Clean them more often if you operate in dusty or
dirty conditions. Replace both elements if they are
excessively dirty of damaged.
Important: Do not start the engine
without the air cleaner elements installed
otherwise extreme engine wear and
damage will result.
To clean the elements, complete the following:
ServicingtheSparkPlug
1.
Stop the engine and pull the wire off of the
spark plug.
Check the spark plug after every 100 operating
hours or yearly whichever comes first. Ensure that
the air gap between the center and side electrodes
is correct before installing the spark plug. Use a
spark plug wrench for removing and installing
the spark plug and a gapping tool/feeler gauge to
check and adjust the air gap. Install a new spark
plug if necessary.
2.
Unscrew the knob and remove the air cleaner
cover (Figure 28).
Type: Champion RCJ-8 or equivalent.
Air Gap: 0.030 inch (0.76 mm)
RemovingtheSparkPlug
1.
2.
Stop the engine.
Figure28
Pull the wire off of the spark plug (Figure 29).
1.
2.
Knob
Cover
3.
4.
Paperelement
Foamelement
3.
Slide the foam element off of the paper
cartridge and clean it as follows:
A. Wash the foam element in a solution of
liquid soap and warm water, squeezing it
to remove dirt, but do not twist because
it may tear.
B. Rinse the element thoroughly in clear water.
C. Dry the element by wrapping it in a clean
rag, squeezing the rag and element.
Figure29
1.
Sparkplugwire
Important: Do not oil either element.
4.
5.
Clean the paper element by tapping it on a
hard surface to knock the dirt out of it.
3.
4.
Clean the area around the spark plug.
Remove the plug from the cylinder head.
Important: Do not wash the paper
element, or clean it with solvent such as
kerosene. Do not use pressurized air to
clean it. Cleaning it with any of these
methods could damage the element.
CheckingtheSparkPlug
1. Look at the center of the spark plug (Figure 30).
If you see light brown or gray on the insulator,
the engine is operating properly. A black
coating on the insulator usually means the air
cleaner is dirty.
Install the foam element over the paper
element.
Important: Never clean the spark plug.
Always replace the spark plug when it has
a black coating, worn electrodes, an oily
film, or cracks.
6.
7.
Install the elements into the air cleaner.
Install the air cleaner cover, securing it with
the knob.
20
| Categories | Blower Vacuum and Sweeper Manuals, Toro Blower and Vacuum Manuals |
|---|---|
| Tags | Toro 62925 |
| Model Number | 62925 |
| Model Year | 2007 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 270000001 - 270999999 |
| Product Name | 206cc OHV Vacuum Blower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Blowers, Vacuums |
| Product Type | Blower, Vacuum |
| Product Series | Gas Powered, Lawn Vacuum / Sweeper / Blower |
| Swath | 76cm |
| Discharge | 1000 cfm/28 cu.m/min |
| Engine Manufacturer | Briggs & Stratton |
| Engine Motor Model # | 126402-0245-E1 |
| Engine Motor Type | 4 Cycle EPA1 |
| Transmission Speed | 1 Speed |
| Transmission Type | Capstan |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)