1.
2.
3.
Clean around the base of the spark plug.
Remove the spark plug.
Examine the spark plug and replace it if it is cracked,
fouled, dirty, or if the electrodes are worn.
Important: Do not clean the electrodes because
grit could enter the cylinder and damage the
engine.
4.
Set the gap between the electrodes on the spark plug
at 0.030 inch (0.76 mm) (Figure 54).
Figure 52
1.
2.
Hex shaft
Aluminum friction plate
3.
Rubber wheel
Important: Do not get oil on the rubber wheel
or the aluminum friction drive plate because the
traction drive will slip (Figure 52).
Figure 54
1.
0.030 inch (0.76 mm)
1.
2.
Drain the gasoline from the fuel tank.
Tip the snowthrower forward onto its auger housing
and block it so that it cannot fall.
5.
Install the spark plug by hand and then torque it to
15
ft-lb (20.4 N·m).
3.
Remove the back cover (Figure 53).
Note: If you do not have a torque wrench, tighten
the plug firmly.
Adjusting the Discharge Chute
Latch
Figure 53
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge chute latch.
1.
Back cover
1.
Remove the fastener on the gear cover (Figure 55),
lift the front of the cover up, and slide it back and
out of the way.
4.
5.
Move the speed selector lever to Position R2.
Dip your finger in automotive engine oil and lightly
lubricate hex shaft.
6.
7.
8.
Move the speed selector lever to Position 6.
Lubricate the other end of the hex shaft.
Move the speed selector lever forward and rearward
a few times.
9.
Install the back cover and return the snowthrower
to the operating position.
Figure 55
Inspecting and Replacing the
Spark Plug
2.
Loosen the bolt on the cable clamp (Figure 56).
Service Interval: Yearly—Inspect the spark plug.
Replace and/or gap it if necessary.
Use a Champion RN4C or equivalent spark plug.
22
| Categories | Snow Blower Manuals, Toro Snow Blower |
|---|---|
| Tags | Toro 38650, Toro Power Max 1128OXE |
| Model Number | 38650 |
| Model Year | 2007 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Serial Number | 270000001 - 270999999 |
| Product Name | Toro Power Max 1128 OXE Snowthrower |
| Product Brand | Toro. Customer Service Representatives are available by phone:
Monday - Friday 7:30 a.m. to 9:00 p.m. (CDT) - Saturday 8:00 a.m. to 8:00 p.m. (CDT) - Sunday 10:00 a.m. to 8:00 p.m. (CDT)
Canada 1-888-225-4886 USA 1-888-384-9939, Snow Blower |
| Product Type | Snowthrower |
| Product Series | Snowthrower, Two Stage Power Max |
| Swath | 28 inch |
| Discharge | Single Stage |
| Engine Manufacturer | Tecumseh |
| Engine Oil Type | 26 oz. (.8l) 5w-30 or 10w / API SH or higher |
| Gearbox Lubricant | 4.5 oz. (133ml) SAE 90 GL5 or higher |
| Engine Motor Model # | OH318SA-221812B |
| Engine Motor Size | 318cc |
| Engine Motor Type | 4 Cycle CARB2, EPA2 |
| Transmission Speed | 6 Forward/2 Reverse |
| Transmission Type | Friction Disc |
| Document File Type | |
| Publisher | toro.com |
| Wikipedia's Page | Toro Company |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)