WARNING: Maintain the proper
hook angle according to the manufac-
turer’s specifications for the chain you
are using. Improper hook angle will in-
crease the chance of kickback which
can result in serious injury.
4.
Check and lower depth gauges.
LOOSEN
Depth Gauge Tool
File
3.
Loosen chain tension by turning ad-
justing wheel (upward direction).
Remove bar clamp.
Depth Gauge
S Place gauge tool on cutter.
S If the depth gauge is higher than
the depth gaugetool,fileitlevelto
the top of the depth gauge tool.
S Maintain rounded front corner of
depth gauge with a flat file.
Bar
Drive Sprocket
Knob
NOTE: The very top of the depth
gauge should be flatwith thefront
half rounded off with a flat file.
Bar
Clamp
4.
Slide guide bar on bar bolts toward
the drive sprocket until guide bar
stops against the sprocket.
Ifyou require furtherassistance or are un-
sure about performing this procedure,
contact your authorized service dealer or
call our customer assistance help line at
1--800--554--6723.
5.
6.
Remove the old chain.
Carefully remove the new chain
from the package. Hold chain with
the drive links as shown.
WARNING: Avoid accidental start-
ing. Always unplug saw from power
source before installing a bar and/or
chain.
Tip of
Bar
CHAIN REPLACEMENT
WARNING:
Wear
protective
gloves when handling chain. The chain
is sharp and can cut you even when it is
not moving.
CUTTERS MUST FACE IN
DIRECTION OF ROTATION
Itisnormalforanewchaintostretchdur-
ing the first15 minutes of operation.You
should recheck your chain tension fre-
quently and adjust the chain tension as
required. See CHECK CHAIN TENSION
section.
Cutters
Depth Gauge
Replace the old chain when it becomes
worn or damaged. Use only the Low
Kickback replacement chain specified
in the listofavailable replacementparts.
Thechainmustcomplywithkickbackre-
quirementsofANSIB175.1 whentested
with this saw.
Drive Links
7. Place the chain around the sprocket
and fit the drivelinks intothe guidebar
groove and then into the teeth of the
sprocket in the tip of the guide bar.
See your authorized service dealer to
replace and sharpen individual cutters
on your chain.
TO REPLACE CHAIN:
1.
2.
Disconnect the chain saw from the
power source.
Loosen and remove bar knob com-
pletely by lifting lever and turning
counterclockwise.
15
| Categories | Chainsaw Manuals, Poulan Chainsaw Manuals |
|---|---|
| Tags | Poulan ES400 |
| Model Year | 2010 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Poulan. Poulan US phone support. Wheeled (Mowers, Tractors, Tillers): 1-800-849-1297 Handheld (Chainsaws, Trimmers): 1-800-554-6723 , Chainsaw |
| Document File Type | |
| Publisher | poulan.com |
| Wikipedia's Page | Poulan |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)