Never fill containers inside a vehicle or on a
truck or trailer bed with a plastic liner. Always
place containers on the ground away from
your vehicle before filling.
Fumes from engine exhaust can cause injury
or death. DO NOT run engine in an enclosed
area. Always provide good ventilation.
ALWAYS maintain unit in safe operating
condition. Damaged or worn out muffler can
cause fire or explosion.
When practical, remove gas-powered
equipment from the truck or trailer and refuel
it on the ground. If this is not possible, then
refuel such equipment on a trailer with a
portable container, rather than from a
gasoline dispenser nozzle.
Keep all hardware properly tightened.
Maintain or replace safety and instruction
labels, as necessary.
NEVER store unit with fuel in fuel tank, inside
a building where any ignition sources are
present.
Keep the nozzle in contact with the rim of the
fuel tank or container opening at all times until
fueling is complete. Do not use a nozzle
lock-open device.
Shut off fuel and allow engine to cool
completely before storing in closed area or
covering unit.
If fuel is spilled on clothing, change clothing
immediately.
For extended storage, clean unit thoroughly.
See Engine Manual for proper storage.
Before tipping unit up onto housing, remove
fuel so no spills will occur. Ensure unit is
secure and will not tip over during
maintenance.
Use only attachments or accessories
designed for your unit.
ALWAYS keep protective structures, guards,
and panels in good repair, in place and
securely fastened. NEVER modify or remove
safety devices.
Check components frequently. If worn or
damaged, replace with manufacturer’s
recommended parts.
DO NOT change engine governor settings or
over-speed engine.
ASSEMBLY
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
3
TOOLS REQUIRED
7/16" Open-end wrench, Pliers
4
ASSEMBLY
5
Handlebar Assembly
1.
Remove wing knobs and release J-bolts
from lower handlebar (figure 3).
2
2.
Unfold upper handlebar.
NOTE: Adjust handlebar to a height
comfortable for the operator (see Handlebar
Height Adjustment on page 11).
1
6
3.
Put J-bolts through the upper handlebar
and lower handlebar holes.
1.
2.
Lower Handle
Bar
Upper Handle
Bar
3. Auger Clutch
Bail
4. Knob
4.
Replace and tighten wing knobs to
secure upper handlebar.
5. J-Bolt
6.
J-Bolt Holes
Figure 3
DS0072
GB - 7
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 938017, Ariens 938018, Ariens 938019, Ariens 938117, Ariens SS522, Ariens SS522EC, Ariens SS722EC |
| Download File |
|
| Document Type | Owner's Manual, Parts Catalog |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)