NEVER operate unit after or during the use of
medication, drugs or alcohol. Safe operation requires
your complete and unimpaired attention at all times.
Use only approved extension cords and receptacles
when starting units equipped with electric starter. DO
NOT connect electric starter cord to any wiring system
that is not a three-wire grounded system.
NEVER allow anyone to operate this unit when their
alertness or coordination is impaired.
ALWAYS allow unit and engine to adjust to outdoor
temperatures before clearing snow.
DO NOT operate unit without wearing adequate winter
outer garments. Wear adequate safety gear, including
safety glasses with side shields, and protective gloves.
Wear proper footwear to improve footing on slippery
surfaces.
Always be sure of your footing, especially when
operating in reverse or leaving the operator’s position.
Walk, never run during operation.
DO NOT overload the machine capacity by attempting
to operate or to clear snow at too fast a rate.
DO NOT wear loose clothing or jewelry and tie back
hair that may get caught in rotating parts.
Slow down and turn corners slowly.
Protect eyes, face and head from objects that may be
thrown from unit. Wear appropriate hearing protection.
Do not operate in reverse unless absolutely necessary.
ALWAYS back up slowly. Always look down and behind
before and while backing.
Avoid sharp edges. Sharp edges can cut. Moving parts
can cut off fingers or a hand.
Disengage attachment drive when traveling from one
work area to another.
ALWAYS keep hands and feet away from all rotating
parts during operation. Rotating parts can cut off body
parts.
Abnormal Vibrations are a warning of trouble. Striking a
foreign object can damage unit. Immediately stop unit
and engine. Remove key and wait for all moving parts
to stop. Remove wire from spark plug. Inspect unit and
make any necessary repairs before restart.
NEVER place your hands or any part of your body or
clothing inside or near any moving part while unit is
running.
ALWAYS keep hands away from all pinch points.
Before cleaning, removing clogs or making any
inspections, repairs, etc.: disengage clutch(es), stop
unit and engine, remove key, allow moving parts to
stop. Allow hot parts to cool.
DO NOT touch unit parts which might be hot from
operation. Allow parts to cool before attempting to
maintain, adjust or service.
Run unit a few minutes after clearing snow to prevent
freeze-up of attachment.
Never direct discharge towards persons or property
that may be injured or damaged by thrown objects. Use
extreme caution on gravel surfaces. Stay alert for
hidden hazards or traffic. Adjust Runners so Scraper
Blade does not contact gravel.
Disengage attachment when not in use. Disengage all
clutches before starting engine. Adjust runners to clear
gravel or crushed rock surfaces safely.
DO NOT throw snow any higher than necessary.
Never leave a running unit unattended. ALWAYS shut
off engine before leaving unit. ALWAYS remove key to
prevent unauthorized use.
Deflected materials can cause injury and property
damage.
Never carry passengers.
Always stand clear of the discharge area when
operating this unit.
Check clutch and brake operation frequently. Adjust
and service as required. All motion of drive wheels and
auger/impeller must stop quickly when control levers
are released.
Fumes from engine exhaust can cause injury or death.
DO NOT run engine in an enclosed area. Always
provide good ventilation.
DO NOT operate on steep slopes. DO NOT clear snow
across the face of slopes. Keep all movement on
slopes slow and gradual. DO NOT make sudden
changes in speed or direction. Use a slow speed to
avoid stops or shifts on slopes. Avoid starting or
stopping on a slope.
ALWAYS disengage attachment, stop unit and engine,
remove key and allow moving parts to stop before
leaving operator’s position.
ROTATING IMPELLER CAN CAUSE SERIOUS
INJURY. NEVER ATTEMPT TO UNCLOG OR CLEAN
UNIT WHILE ENGINE IS RUNNING.
DO NOT park unit on a slope unless absolutely
necessary. When parking on a slope always block the
wheels.
Read, understand, and follow all instructions in the
manual and on the machine before starting.
Understand:
Use extra care when loading or unloading unit onto
trailer or truck.
•
•
•
How to operate all controls.
The functions of all controls.
How to STOP in an emergency.
Secure unit chassis to transport vehicle. NEVER
secure from rods or linkages that could be damaged.
Before starting engine, disengage control(s).
DO NOT transport machine while engine is running.
GB - 7
| Categories | Ariens Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Ariens 939003, Ariens ST520E |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | Ariens, Snow Blower |
| Document File Type | |
| Publisher | ariens.com |
| Wikipedia's Page | Ariens |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)