ASSEMBLY INSTRUCTIONS
NOTE: Before setting up your cultivator / edger,
ADJUSTING TINE DEPTH
To adjust the wheel support bracket proceed as follows:
disconnect the spark plug wire from the spark
plug.
1.
Stop engine and disconnect spark plug to avoid
accidental starting.
POSITIONING THE HANDLEBARS
1.
Loosen the two knobs on the inside of the
handlebars (Fig. 1).
2. Remove cotter pin from the clevis pin and slide clevis
pin out of tailpiece bracket (Fig. 3).
2.
With the unit upright, swing the handlebars up into
the operating position (Fig. 1).
3. Slide the wheel support bracket up or down in the
tailpiece, aligning the holes to the desire height.
NOTE: Take care not to pinch the throttle cable or
switch wires when positioning the handlebar.
4.
Place the clevis pin through the hole and secure with
cotter pin.
3.
Tighten the knobs to secure the handlebars in place.
Clevis Pin
Cotter Pin
NOTE: Do not over-tighten the knobs.
4.
Reconnect the spark plug wire to the spark plug.
Wheel
Support
Bracket
Tailpiece Bracket
Fig. 3
ATTACHING THE EDGER WHEEL AND
BLADE
To convert the cultivator to an edger proceed as follows:
1.
Push the On/Off switch to Off (O) position to stop
engine and tines and disconnect spark plug to avoid
accidental starting.
NOTE: It may be necessary to lay the cultivator / edger
back in a horizontal position on a flat level surface
with the upper handle touching the ground.
2.
Remove the click pin from each end of the tine shaft
and slide the tines off the shaft.
3.
Slide the edger wheel, with the hub facing inward,
onto the right side of the tine shaft and secure with
the click pin in the inside hole (Fig. 4).
Fig. 1
4.
5.
Slide the edger blade with the hub facing out onto
the left side of tine shaft and secure with the click pin
in the inside hole (Fig. 4).
Handlebars
The edger guide line indicates where cutting will
occur. Guide the unit along a flowerbed, sidewalk, or
driveway so the edger guide line is above the desired
line of cut.
Bolt
Handlebar
Knob
Edger Guide
Line
Hole
Washer
Fig. 2
Hub
Edger Wheel
Tine Shaft
Edger Blade
Click Pin
Fig. 4
7
| Categories | Craftsman Lawn Mower Manuals, Craftsman Tiller Cultivator Manuals, Lawn Mower Manual, Tiller Cultivator Manuals |
|---|---|
| Tags | Craftsman 316.292711 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Craftsman. Customer Service Representatives are available by phone: Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | craftsman.com |
| Wikipedia's Page | Craftsman (tools) |
| Copyright | Attribution Non-commercial |
(1 votes, average: 3 out of 3)
Lawn and Garden readers have rated Craftsman 316.292711 4 Cycle Cultivator Edger Lawn Mower Owners Manual 3.0 out of 3.0 based on 1 product reviews. This belonged to my sister who died last year. I need info on the electric start.