ASSEMBLY
aTTa CHing THe HanDLe
1.
Remove the hairpin clips from the handle brackets and remove the
carriage screws and wing nuts from the lower handle.
a. Place the bottom holes in lower handle over the pins on the
handle brackets and secure with hairpin clips. See Figure 2.
b. theInsertinsidecarriageand securescrewswiththroughwinguppernuts. holeSee Figurein lower2.handle from
a. Unfold the upper handle until it aligns with lower handle. Make
sure the rope guide is on the right side of upper handle. See
Figure 3.
2.
IMPORTANT: Make sure the cables are routed outside the lower
handle. Also, do not crimp the cables while lifting up the handles.
b. Secure the two handles by tightening the handle knobs (carriage
bolts must be seated properly into the handle). See Figure 3.
Pull the two cable ties attached to the cables tight approximately
8 inches from each cable end and place the cables into the cable
3.
4.
Figure 2
guide.
Loosen the wing nut that secures the rope guide to the right side of
Rope Guide
upper handle.
a. Pull the starter rope out of the engine slowly. See Figure 4.
b. SeeSlip theFigurestarter4. rope into the rope guide. Tighten the wing nut.
B
A
Figure 3
B
A
Figure 4
| Categories | Blower Vacuum and Sweeper Manuals, Craftsman Blower and Vacuum Manuals, Craftsman Lawn Mower Manuals, Lawn Mower Manual |
|---|---|
| Tags | Craftsman 675 247.77013.0 |
| Download File |
|
| Document Type | Operator's Manual |
| Language | English |
| Product Brand | Craftsman. Customer Service Representatives are available by phone: Canada 1-888-225-4886 USA 1-888-384-9939, Lawn Mower |
| Document File Type | |
| Publisher | craftsman.com |
| Wikipedia's Page | Craftsman (tools) |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)