TROUBLESHOOTING
ƽ CAUTION
Disconnect the machine from the power
source before making any repair.
Symptom
Cause
Solution
Motor will not start On/Off switch is in the “OFF” Turn switch to the “ON” (I)
(0) position.
position
Power cord is not plugged in. Plug in power cord.
Electrical outlet does not
supply adequate power.
Try a different outlet.
Tripped GFCI plug.
Press “RESET” button on GFCI
plug.
Unit does not
reach high
pressure.
Diameter of garden hose is
too small.
Replace with a 5/8 inch or
larger garden hose.
Water supply is restricted.
Check garden hose for kinks,
leaks and blockage.
Not enough inlet water supply. Open water source full force.
Water inlet filter is clogged.
Remove filter and rinse out in
warm water.
Spray wand is on low
pressure position.
Turn spray wand to high
pressure position.
Output pressure
varies high and
low.
Not enough inlet water supply. Turn water on full force. Check
garden hose for kinks, leaks or
blockage.
Pump is sucking air.
Check that hoses and fittings
are air tight. Turn off machine
and purge pump by squeezing
trigger gun until a steady flow of
water emerges through the
nozzle.
Water inlet filter is clogged.
Remove filter and rinse out in
warm water.
Discharge nozzle is
obstructed.
Blow out or remove debris with
a fine needle.
Calcified gun, hose or spray Run distilled vinegar through
wand.
detergent suction tube.
English 15
| Categories | Kärcher Pressure Washer Manuals, Pressure Washer Manuals |
|---|---|
| Tags | Kärcher K 2.350 |
| Download File |
|
| Language | English, Français, Español |
| Product Brand | Kärcher. Kärcher US Home and garden support phone: 1-800-537-4129 Kärcher international support: http://www.karcher.com/start/choose_your_language.htm, Pressure Washer |
| Document File Type | |
| Publisher | karcherresidential.com |
| Wikipedia's Page | Kärcher |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)