TROUBLESHOOTING
Disconnect the machine from the power source before making any repair.
Symptom
Cause
Solution
Motor will not start
On/Off switch is in the
“OFF” position.
Turn switch to the “ON” position
Power cord is not plugged in. Plug in power cord.
Extension cord is too long.
Extension cord is not proper
gauge.
Replace extension cord with either
a 25 ft. 12/2 gauge cord or a 50 ft.
gauge cord.
10/2
Extension cord is damaged.
Electrical outlet does not
supply adequate power.
Try a different outlet.
Tripped circuit breaker
Reset breaker (power supply) or
ground fault circuit interrupter.
Unit does not reach Diameter of garden hose is
Replace with a 3/4 inch garden
hose.
high pressure.
too small.
Water supply is restricted.
Check garden hose for kinks, leaks
and blockage.
Not enough inlet water supply. Open water source full force.
10
Water inlet filter is clogged.
Remove filter and rinse out in warm
water.
Soap nozzle installed.
Remove soap nozzle and connect
spray wand.
Output pressure
varies high and low.
Not enough inlet water supply. Turn water on full force. Check garden
hose for kinks, leaks or blockage.
Pump is sucking air.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until
a steady flow of water emerges
through the nozzle.
Water inlet filter is clogged.
Remove filter and rinse out in warm
water.
Discharge nozzle is
obstructed.
Blow out or remove debris with a
fine needle.
Calcified gun, hose or spray Run distilled vinegar through
wand. detergent suction tube.
Categories | Kärcher Pressure Washer Manuals, Pressure Washer Manuals |
---|---|
Tags | Kärcher K 210 M |
Download File |
|
Language | English |
Product Brand | Kärcher. Kärcher US Home and garden support phone: 1-800-537-4129 Kärcher international support: http://www.karcher.com/start/choose_your_language.htm, Pressure Washer |
Document File Type | |
Publisher | karcherresidential.com |
Wikipedia's Page | Kärcher |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)