Starting
Switching Off
General Information
-Dirt in the feed water could lead to the -After using a detergent, the appliance
appliance being damaged. To avoid this
Purpose
pendshouldthebedetergentrinsed clear.suctionTohosedo this,ina con-sus- -Use the appliance to clean machines,
vehicles, buildings, tools etc.
risk, we recommend fitting a filter with
3/4"connection .
tainerofcleanwater,andrunthe pumpfor
-Clean facades, terrasses, garden equip-
ment etc. without detergent onlywith the
high-pressure spray.
-Engines mayonlybe cleanedatlocations
with appropriate oil separators (environ-
mentalprotection).
-If you are using an extension cable, it approx. 1 minute.
should always be completely unwound -Pullthe triggeruntilthere is nomore pres-
fromthe cable drumandhave a sufficient sure in the appliance, and secure the
cross-sectional area (10 m = 1,5 mm², trigger with the safety ratchet against
30m
= 2,5 mm²).
unintentional opening.
-Frostwilldestroyan appliance which has
not been completely emptied of water.
SafetyEquipment
Operation with high pres sure
When the hand-held spary gun is closed,
the overflow valve switches off the
appliance via a pressure-operated switch.
The overflowvalve is also a safetydevice
againstexceedingthe maximumallowable
working pressure.
-The appliance is equipped with a pressu- The appliance should be stored in
re-operatedswitch. The motorstarts only a frost-free room.
ifthe lever ofthe gun is pulled.
-The safetyratchetdoes notlockthe lever
of the gun during operation but only !Note: Disconnect the appliance fromthe
prevents it fromopening unintentionally. power mains before allrepair work.
Troubleshooting
Appliance does not Work
-Checkwhether the voltage shown on the
Suction operation
-Allow the pump to operate without the rating plate corresponds to that of the
high-pressure hose untilwaterappears at power source.
the high-pressure outlet without any -Check the connector cable for damage.
morepressurebubbles.Thenhose. re-attach the high- Appliance does not reach Pressure
-Set the spray lance to the maximum
working pressure.
-Vent the appliance.
Operation with Detergent
-We recommend that you use detergent
-Clean the strainer in the water
sparinglyforthe sake ofthe environment.
connection.
Observe the recommended dosage on
the detergent label.
-Checkthe inlet water flowrate.
-Byofferingyouan individualisedrange of -Checkallinletpipes tothe pumpforleaks
or block-age.
clea-ningandpreservingagents,Kärcher
guarantees trouble-free operation of the Strong Pressure Fluctuations
unit.
-Cleanthe high-pressure nozzle. Remove
dirtfromthe nozzle hole witha needle and
then rinse out with water fromthe front.
-We recommend the following cleaning
methods:
Pump Leaks
-3
drops perminute are permissible.Inthe
case ofmore serious leakage,youshould
Step 1: Loosening dirt
Spray on detergent sparingly and allow contact the authorized customer service.
to react for a short time.
No Detergent Suction
Step 2: Removing dirt
Spray offthe loosened dirt with the
high-pressure spray.
-Set the spray lance to the minimum
working pressure.
-Clean the detergent suction hose with fil-
ter, and check for leaks.
Spare Parts
-A selection of the most common spare
parts numbers is listedatthe endofthese
operating instructions.
8
| Categories | Kärcher Pressure Washer Manuals, Pressure Washer Manuals |
|---|---|
| Tags | Kärcher K 670 M |
| Download File |
|
| Language | English, Français |
| Product Brand | Kärcher. Kärcher US Home and garden support phone: 1-800-537-4129 Kärcher international support: http://www.karcher.com/start/choose_your_language.htm, Pressure Washer |
| Document File Type | |
| Publisher | karcherresidential.com |
| Wikipedia's Page | Kärcher |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)