K8000G Manual 11/30/01 5:06 PM Page 10
CLEANING TIPS - continued
TROUBLESHOOTING
Barbecue Grills, Outdoor
Power Equipment &
Recommendations
Symptom
Cause
Solution
Fill gas tank.
Add oil.
• Before cleaning any surface an inconspic-
uous area should be cleaned to test spray
pattern and distance for maximum clean-
ing results.
Gardening Tools
Engine will not
start
No gasoline.
Low oil level.
(with or without detergent)
Pre-rinse cleaning surface with fresh water.
If using Kärcher All Purpose Cleaner or
Degreaser, place detergent suction tube
directly into cleaning solution and apply
detergent at low pressure. Allow Kärcher
detergent to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure keeping the spray
nozzle approximately 6 inches from the
cleaning surface. For removing extremely
stubborn dirt, it may be necessary to move
the spray nozzle even closer to the surface
for greater dirt cutting action.
•
If painted surfaces are pealing or chipping,
use extreme caution as pressure washer
may remove the loose paint from the
surface.
Choke is not in correct
position.
Slide choke lever to “CHOKE”
position.
Engine throttle is not in
correct position.
Position the throttle to “FAST”.
For additional
Use extreme caution when cleaning decks,
siding, and other sensitive surfaces as the
pencil jet may cause damage if not used
correctly.
engine problems
refer to the engine
owners manual.
Pressure built up in the
high pressure washer.
Squeeze the trigger to release the
pressure.
Unit does not reach Diameter of garden hose is
too small.
Replace with a 3/4 inch garden
hose.
high pressure.
Water supply is restricted.
Check garden hose for kinks, leaks
and blockage.
Patio & Lawn Furniture
(with or without detergent)
Not enough inlet water supply. Open water source full force.
Pre-rinse furniture and surrounding area with
fresh water. If using Kärcher All Purpose
Cleaner, place detergent suction tube direct-
Water inlet filter is clogged.
Remove filter and rinse out in warm
water.
9
10
ly into cleaning solution and apply to surface
at low pressure. Allow Kärcher All Purpose
Cleaner to remain on surface 1-3 minutes.
Do not allow detergent to dry on surface.
Rinse at high pressure in a sweeping motion
keeping the spray nozzle approximately 6
inches from the cleaning surface. For best
results, clean from top to bottom and from
left to right.
Nozzle is in “CHEM”
position.
Turn nozzle to high pressure position.
Output pressure
varies high and low.
Not enough inlet water supply. Turn water on full force. Check garden
hose for kinks, leaks or blockage.
Pump is sucking air.
Check that hoses and fittings are air
tight. Turn off machine and purge
pump by squeezing trigger gun until
a steady flow of water emerges
through the nozzle.
OPTIONAL CLEANING ACCESSORIES
Water inlet filter is clogged.
Remove filter and rinse out in warm
water.
Optional cleaning accessories are available to further enhance your cleaning capabilities.
Call Kärcher customer service hotline (1-800-537-4129) for details.
Discharge nozzle is
obstructed.
Blow out or remove debris with a
fine needle.
Calcified gun, hose or spray Run distilled vinegar through
wand. detergent suction tube.
Categories | Kärcher Pressure Washer Manuals, Pressure Washer Manuals |
---|---|
Tags | Kärcher K 8000 G |
Download File |
|
Language | English |
Product Brand | Kärcher. Kärcher US Home and garden support phone: 1-800-537-4129 Kärcher international support: http://www.karcher.com/start/choose_your_language.htm, Pressure Washer |
Document File Type | |
Publisher | karcherresidential.com |
Wikipedia's Page | Kärcher |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)