SECTION 2: ASSEMBLING YOUR SNOW THROWER
NOTE: This Operator’s Manual covers several models.
Snow thrower features vary by model. Not all
features discussed in this manual are applicable to all
1
snow thrower models.
Contents of Carton
Carton contents are listed below:
•
•
•
Two Ignition Keys
Bottle of 2 cycle oil
Extension Cord (select models only)
NOTE: All references to left or right side of the snow
thrower is from the operating position only.
WARNING: Disconnect the spark plug wire
and ground it against the engine to prevent
unintended starting.
Positioning the Upper Handle
•
•
Remove packing material, if present.
Making sure not to pinch the cable in the process,
pivot the upper handle into the operating position as
illustrated until it clicks into place.
2
•
Tighten the wing knobs to secure the handle in
place.
Assembling the Discharge Chute
For shipping reasons, the snow thrower has been
packaged with the upper chute pivoted all the way
down. To pivot it upward, proceed as follows:
•
•
•
Turn the chute until the chute opening is facing
straight ahead.
Remove the wing knob, flat washer and carriage
bolt from the lower chute.
Pivot the upper chute upward over the lip on the
lower chute so that there is NO gap between the
upper chute and the lower chute.
3
•
Resecure with the hardware just removed.
2
IMPORTANT:Do not use the chute handle to lift the snow
thrower.
3
1
5
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD 262, MTD S235, MTD S265, MTD Single Stage, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)