MTD 380 Two Stage Snow Blower Owners Manual

Reassemble new shave plate, making sure heads
of the carriage bolts are to the inside of the housing.
Reinstall skid shoe. Tighten securely.  
Replace with new belt after replacing the drive belt.
Follow instructions below to replace the drive belt.
Engine Pulley
Shear Bolt
Auger Belt
Hex Lock Nut
Auger Pulley
Washer
Idler Bracket
Figure 11
Carriage
Drive Belt
Bolt
Carriage
Bolt
Hex Nut
NOTE: Replace the drive belt before reassembling the
new auger belt.
Hex
Nut
Skid
Shoe
Shave
Plate
Tip the snow thrower up and forward so that it rests
on the auger housing.
Remove the spring that connects the transmission
to a bolt on the engine frame. See Figure 12.
Figure 9
Replacing Belts
NOTE: There are two belts on this snow thrower: auger
belt and drive belt. It is recommended that both belts be
replaced at the same time.
Remove the spark plug wire from the spark plug
and ground it against the engine.
Drain gasoline from the gas tank, or place a piece
of plastic sheet underneath the gas cap to prevent
gasoline leakage.
Push the belt cover to release the plastic tabs.  Pull
the belt cover out from around the engine and the
chute. Remove it away and save. See Figure 10.
Spring
Belt Cover
Drive Pulley
Drive Belt
Auger Pulley
NOTE: Transmission shown pushed forward
Figure 12
Pivot the transmission forward to release pressure
on the drive belt.
Remove the drive belt from around the engine
pulley, and away from the unit.
Place the new drive belt into the groove on the
engine pulley. See Figure 12.
Tilt the transmission forward and position the drive
belt on the drive pulley.
Tab
Figure 10
Auger Belt
Slip the front auger belt off the engine pulley
pushing it down between the idler bracket and the
engine pulley. See Figure 11.
Reconnect the spring to the bolt on the engine
frame and secure the transmission.
Reassemble the belt cover on the snow thrower.
Squeeze the auger control bail to release tension
on the auger belt; remove the belt.
12
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website