MTD 450 Push Lawn Mower Owners Manual

8
Troubleshooting
Problem
Cause
Remedy
Engine Fails to start
1.   Blade control disengaged.
1.   Engage blade control.
2
3
4
.   Spark plug boot disconnected.
2.   Connect wire to spark boot.
.   Fuel tank empty or stale fuel.
3.   Fill tank with clean, fresh gasoline.
.   Engine not primed (if equipped with primer).
4.   Prime engine as instructed in the Operation
section.
5
6
7
.   Faulty spark plug.
.   Blocked fuel line.
.   Engine flooded.
5.   Clean, adjust gap, or replace.
6.   Clean fuel line.
7.   Wait a few minutes to restart, but do not
prime.
8
9
.   Fuel valve (if equipped) closed.
8.   Open fuel valve. See engine manual.
9.   Choke engine. See engine manual.
1.   Connect and tighten spark plug boot.
.   Engine not choked (if equipped with choke).
Engine runs erratic
1.   Spark plug boot loose.
2
.   Blocked fuel line or stale fuel.
2.   Clean fuel line; fill tank with clean, fresh
gasoline.
3
4
5
6
.   Vent in gas cap plugged.
.   Water or dirt in fuel system.
.   Dirty air cleaner.
3.   Clear vent.
4.   Drain fuel tank. Refill with fresh fuel.
5.   Refer to engine manual.
6.   Push CHOKE knob in.
.   Unit running with CHOKE (if equipped)
applied.
Engine overheats
1.   Engine oil level low.
1.   Fill crankcase with proper oil.
2.   Clean area around and on top of engine.
1.   Adjust gap to .030”.
2
.   Air flow restricted.
Occasional skips
(hesitates) at
high speed
1.   Spark plug gap too close.
Idles poorly
1.   Spark plug fouled, faulty, or gap too wide.
1.   Reset gap to .030” or replace spark plug.
2.   Refer to engine manual.
2
.   Dirty air cleaner.
1.   Cutting blade loose or unbalanced.
.   Bent cutting blade.
1.   Wet grass.
Excessive Vibration
1.   Tighten blade and adapter. Balance blade.
2.   See an authorized service dealer.
2
Mower will not
mulch grass
1.   Do not mow when grass is wet; wait until
later to cut.
2
.   Excessively high grass.
2.   Mow once at a high cutting height, then
mow again at desired height or make a
narrower cutting path.
3
.   Dull blade.
3.   Sharpen or replace blade.
Uneven cut
1.   Wheels not positioned correctly.
.   Dull blade.
1.   Place all four wheels in same height position
(if equipped with individual height adjusters).
2
2.   Sharpen or replace blade.
1
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 40 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website