4
Operating
Your Log
Splitter
Control Handle
The• control handle has three positions. See Figure 4-2.
FORWARD: Move control handle FORWARD or
DOWN to move wedge to split wood.
NOTE: Control handle will return to neutral position as
soon as handle is released.(Forward Position only)
To return
wedge
•
NEUTRAL: Release the control handle or move the
lever to neutral position to stop the wedge movement.
Neutral
•
REVERSE: Move control handle BACK or UP to return
the wedge toward the cylinder. The control handle
stays in the return (Reverse) position and returns to
neutral automatically when fully retracted.
To stop
wedge
To split wood
NOTEneutral: positionReversemanually,position mayif necessary.also be operated back to
Figure 4-
Stopping Engine
NOTE: Gasoline can be added to the engine when the
log splitter is in either the horizontal or vertical position.
However, there are less obstructions when the unit is in
the vertical position.
1
. pMoosviteiotnh.rottle control (if equipped) to STOP or OFF
2.
3.
Turn off the engine switch, if so equipped.
WARNING
Disconnect spark plug wire and ground against the
engine to prevent unintended starting.
Read, understand, and
follow all instructions
and warnings on the
machine and in this
manual before operat-
ing.
Starting Engine
1.
Attach spark plug wire to spark plug. Make certain
the metal cap on the end of the spark plug wire is
fastened securely over metal tip of the spark plug.
WARNING: Read, understand, and
follow all instructions and warnings on
the machine and in this manual before
2.
Turn fuel valve (or engine switch), if equipped, to the
ON position.
3.
4.
Move choke lever, if equipped, to CHOKE position.
operating.
If the engine is equipped with a primer, follow
Wear leather work
instructions in the engine manual to prime it.
gloves, safety shoes,
ear protection, and
safety glasses when
operating a log splitter.
Ensure safe footing.
WARNING: Wear leather work gloves,
safety shoes, ear protection, and safety
glasses when operating a log splitter.
Ensure safe footing.
5.
6.
Turnposition.the throttle control (if equipped) to the FAST
Grasp starter handle and pull rope out slowly until
engine reaches start of compression cycle (rope will
pull slightly harder at this point).
Gas and Oil Fill-Up
7. Pull rope with a rapid, full arm stroke. Keep firm grip
on starter handle. Let rope rewind slowly. Repeat
until engine cranks.
Use extreme care when
handling gasoline.
Gasoline is extremely
flammable and the
vapors are explosive.
Never fuel machine
indoors or while the
engine is hot or run-
ning.
1.
Service the engine with gasoline and oil as instructed
in the engine manual packed with your log splitter.
Read instructions carefully.
8.
After engine starts, move choke lever (if equipped)
to OFF position. Place throttle lever to the speed
desired.
WARNING: Use extreme care when han-
dling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running.
9.
In cold weather, run wedge up or down beam 6 to 8
times to circulate the hydraulic fluid.
WARNING: When starting a warm
engine, the muffler and surrounding
areas are hot and can cause a burn.
Do not touch.
When starting a warm
engine, the muffler and
surrounding areas are
hot and can cause a
burn. Do not touch.
IMPORTANT: Your log splitter may be shipped with motor
oil in the engine. You MUST check the oil level before
operating. Be careful not to overfill.
Categories | Lawn Mower Manual, MTD Lawn Mower Manuals |
---|---|
Tags | MTD 500 |
Download File |
|
Document Type | Owner's Manual |
Language | English |
Product Brand | MTD, Lawn Mower |
Product Type | Walk Behind Mower |
Document File Type | |
Publisher | mtdproducts.com |
Wikipedia's Page | MTD Products |
Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)