MTD 5DM Series Log Splitter Lawn Mower Owners Manual


2.
3.
4.
Insertscrew theit in.dipstickSee Figureinto the9-2.engine block, but do not
Ifthethedipstick.level is low, slowly add oil to the upper limit on
Tighten dipstick firmly before starting  engine.
IMPORTANT: Do not overfill. Overfilling with oil may
cause smoking, hard starting, spark plug  fouling, or oil
saturation of air cleaner.
Operating
Your
Oil Fill Cap/
Dipstick
Engine
Fuel Recommendations
Use automotive gasoline (unleaded or low leaded to
minimize combustion chamber deposits)  with a minimum
of 87 octane. Gasoline with up to 10% ethanol or 15%
MTBE (Methyl Tertiary Butyl Ether) can be used. Never
use an oil/gasoline mixture  or dirty gasoline. Avoid
getting dirt, dust, or water in the fuel tank.  DO NOT use
E85 gasoline.
Upper Level
Figure 9-2: Checking the oil level.
WARNING: Gasoline is extremely  flam-
mable and is explosive under certain
conditions.
Refuel in a well-ventilated area  with the engine
stopped. Do not smoke or allow flames  or sparks
in the area where the engine is refueled  or where
gasoline is stored.
Do not overfill the fuel tank (there  should be no fuel
in the filler neck).  After refueling, make sure the tank
cap is closed properly and securely.
WARNING
Gasoline is extremely
flammable and is
explosive under
certain conditions.
Be careful not to spill fuel when refueling.  Spilled
fuel or fuel vapor may ignite. If any fuel is spilled,
make sure the area is dry before  starting the engine.
Avoidbreathingrepeatedof vapor.or prolonged contact with skin  or
Always keep hands
and feet clear of
equipment moving
parts. Do not use a
pressurized starting
fluid. Vapors are flam-
mable.
Check Fuel Level
1.
2.
Clean around fuel fill before removing cap to fuel.
Fill tank to approximately one inch below lowest
portion of neck to allow for fuel expansion. Be careful
not to overfill.
Figure 9-3: Starting the log splitter.
NOTE: Use of the choke may not be necessary  if the
engine is warm or the air temperature is high.
IMPORTANTminutes.        : Before refueling, allow engine to cool two
3.  Turn engine switch to on.
4.
Pull the starter grip lightly until resistance  is felt,
then pull rapidly to overcome compression, prevent
kickback and start engine. See Figure 9-3.  If engine
does not start after ten seconds of repeated pulls, wait
a few minutes and repeat.
Starting The Engine
WARNING: Always keep hands and
feet clear of equipment moving parts.
Do not use a pressurized starting  fluid.
Vapors are flammable.
IMPORTANT: Do not allow the starter grip to snap
back against the rope guide. Return it gently to prevent
damage to the starter.
1.
2.
Check to make sure that cylinder is in the operating
“Lock” position, engaging  safety switch.
5.
When engine warms up, push in the choke knob.
Pull out the choke knob located on the engine. See
Stopping The Engine
Figure 9-3 inset.
1.
Turn off the engine switch.
1
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 52 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website