Leveling the Deck (Side to Side)
Steering Adjustment
If the cutting deck appears to be mowing unevenly, a side to side If the tractor turns tighter in one direction than the other, or if
adjustment can be performed. Adjust if necessary as follows:
the ball joints are being replaced due to damage or wear, the
steering drag links may need to be adjusted.
1
2
.
.
With the tractor parked on a firm, level surface, place the
deck lift lever in the top notch (highest position) and rotate
both blades so that they are perpendicular with the tractor. into the ball joint on the left side and the ball joint on the right
Adjust the drag links so that equal lengths of each are threaded
side:
Measure the distance from the outside of the left blade
tip to the ground and the distance from the outside of the
right blade tip to the ground. Both measurements taken
should be equal. If they’re not, proceed to the next step.
1.
Remove the hex nut on the top of ball joint. See Fig. 6-7.
3
.
Loosen, but do NOT remove, the hex bolt on the left deck
hanger bracket. See Fig. 6-6.
Adjustment
Gear
Hex Nut
Drag Link
Hex Bolt
Ball Joint
Figure 6-
2
3
.
.
Thread the ball joint inward to shorten the drag link.
Thread the ball joint outward to lengthen the drag link.
Figure 6-6
Replace the hex nut after proper adjustment is achieved.
NOTE: Threading the ball joints too far onto the drag links
will cause the front tires to “toe-in” too far. Proper toe-in is
between 1⁄16” and 5⁄16”.
4
.
Using a wrench, raise or lower the left side of the deck by
turning the adjustment gear. See Fig. 6-6.
The deck is properly leveled when both blade tip measurements
taken earlier are equal. Retighten the hex bolt on the left deck
hanger bracket when proper adjustment is achieved.
Front tire toe-in can be measured as follows:
1
.
Place the steering wheel in position for straight ahead
travel.
Parking Brake Adjustment
2
.
In front of the axle, measure the distance horizontally from
the inside of the left rim to the inside of the right rim. Note
the distance.
If the tractor does not come to a complete stop when the brake
pedal is completely depressed, or if the tractor’s rear wheels
can roll with the parking brake applied (and the hydrostatic
relief valve open), the brake is in need of adjustment. See your
authorized MTD service dealer to have the brake properly
adjusted.
3
4
.
.
Behind the axle, measure the distance horizontally from
the inside of the left rim to the inside of the right rim. Note
the distance.
The measurement taken in front of the axle should be
between 1/16” and 5/16” less than the measurement taken
behind the axle.
Adjusting the Seat
Refer to the Set-Up and Assembly section of this manual for seat
adjustment instructions.
Warning! Before operating the tractor, make sure
the seat is engaged in the seat-stop. Engage the
parking brake. Stand behind the machine and pull
back on seat until it clicks into place.
sectiOn 6 — Maintenance & adjustMents
3
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals |
|---|---|
| Tags | MTD 600 Lawn Tractor |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)