MTD 643 663 Snow Blower Owners Manual

wheel hub.This position gives power drive to the left
wheel only, making the unit easier to maneuver.
Inside Hole
In Axle
Both Wheels Driving
Rotate wheel assembly to align hole in the hub with
the inner hole on the axle shaft. Insert klick pin in
the hole. Outer axle shaft hole should be visible.
IMPORTANT: NEVER operate the snow thrower with the
click pin inserted through both the RIM and the
OUTSIDE HOLE in the axle. Doing so can result in
serious damage to the drive system.
Click Pin In
Outside Hole
Figure 12
SECTION 6:  MAINTAINING YOUR SNOW THROWER
WARNING:  Before  lubricating,  repairing,
or inspecting, disengage all clutch levers
and  stop  engine.   Wait  until  all   moving
parts   have  come   to   a  complete   stop.
Disconnect spark plug wire and ground it
against the  engine to prevent unintended
starting.
Gear Shaft
Lubricate the gear shaft with 6-n-1 grease at least once
a season or after every 25 hours of operation (available
at automotive stores, or order part number 737-0170).
Refer to Figure 9.
IMPORTANT: Keep all grease and oil off of the rubber
friction wheel and aluminum drive plate.
Lubrication
Gear Case
The gear case is lubricated with grease at the factory
and it does not require checking. If disassembled for
any reason, lubricate with 2 ounces of Shell Alvania
grease EPR00, part number 737-0168.  
Engine
Refer to the separate engine manual packed with your
unit for all engine lubrication instructions.
WARNING: If any adjustments need to be
made  to  the  engine  while  the  engine  is
running (e.g. carburetor), keep clear of all
moving parts. Be careful of muffler, engine
and other surrounding heated surfaces.
IMPORTANT: Do not overfill the gear case, since
damage to the seals could result. Be sure the vent plug
is free of grease in order to relieve pressure.
See Figure 14.
Auger Shaft
Wheels
At least once a season, remove the shear bolts on the
auger shaft. Spray lubricant inside the shaft and
lubricate the plastic auger bearings at least once a
season. See Figure 14.
Oil or spray lubricant into bearings at wheels at
least once a season. Pull klick pin, remove wheels,
clean and coat axles with a multipurpose
automotive grease. See Figure 13.
Vent Plug
Klick Pin
Axle
Figure 13
Chute Directional Control
Plastic
Bearing
Plastic
Bearing
The worm gear on the chute directional control
should be greased with multipurpose automotive
grease.
Shear Bolts
Figure 14
12
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website