MTD 760 77 Transmatic Lawn Tractor Mower Owners Manual

3
Setting Up
Your Lawn
Tractor
Figure 3-7
WARNING: Before operating  this
machine, make sure the seat is engaged
in the seat stop, stand behind the
machine and pull back on seat until fully
engaged into stop.
Figure 3-8
2
.  Check the gauge wheels for contact  or excessive
clearance with the surface below. The deck  gauge
wheels should have between ¼-inch and ½-inch
clearance above the ground as follows:
WARNING
3.
To adjust the position of the seat on models equipped
with a seat adjustment lever, move the seat adjustment
lever (located under the seat) to the left and slide the
seat forward or rearward. See Figure 3-7. Make sure
seat is locked into position before operating the tractor.
Maximum tire pres-
sure under any
If the gauge wheels have excessive clearance or
circumstances is 30
psi. Equal tire pressure
should be maintained
at all times.
contact with the surface, adjust as follows:
a.   Raise the deck lift handle to its highest setting.
Identifying the Mulch Plug (if so
b.   Remove the gauge wheels by removing the lock
nuts and shoulder screws which secure them to
the deck. See Fig. 3-9
equipped)
On tractor models so equipped, a mulch  plug can either
be found within the cutting deck’s discharge  opening or
packed separately with your unit.
c.   Placeheightthesetting.deck lift lever in the desired mowing
d.   Reinsert the shoulder screw (with each gauge
wheel) into the index hole that leaves approxi-
mately ½-inch between the bottom of the wheel
and the pavement.
Refer to Leveling the Deck in the  Maintenance section
of this manual for more detailed instructions regarding
various deck adjustments.
NOTE: Refer to Mulching in the Operation section  of this
manual for more detailed information.
If you’d prefer to operate the cutting deck without mulch-
ing, simply remove the mulch plug by unthreading the
plastic wing nut which fastens it to the cutting  deck. This
will allow the clippings to discharge out  of the discharge
opening during operation. See Figure 3-8.
Tire Pressure
WARNING: Maximum tire  pressure un-
der any circumstances is 30 psi. Equal
tire pressure should be maintained  at
all times.
The tires on your unit may be over-inflated for shipping
purposes. Reduce the tire pressure before operating
the tractor. Recommended operating tire pressure is
approximately 10 p.s.i for the rear tires & 14 p.s.i. for the
front tires. Check sidewall of tire for maximum p.s.i
Setting the Deck Gauge Wheels
(if so equipped)
Move the tractor on a firm and level surface, preferably
pavement, and proceed as follows
1.
Select the height position of the cutting  deck by plac-
ing the deck lift lever in the normally desired  mowing
height setting (any of the six different cutting  height
notches on the right fender).
Figure 3-9
11
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 60 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website