MTD 830 Series 21 Inch Rotary Mower Lawn Mower Owners Manual

3
Setup and
Adjustment
WARNING: Never operate  mower unless
the hooks on the grass catcher are  firmly
seated on the pivot rod and the rear
discharge door rests firmly against  top of the grass
catcher.
10.To convert to side  discharge, make sure grass
catcher is off of the unit and rear discharge door  is
closed.
a.   On the side of the mower, lift the mulching  plug.
b.   Slide two hooks on side discharge  chute under
8.
The battery pack within the Electric  Starter must be
charged 8 to 10 hours before use. Refer to “Charging
Battery” in the Maintenance section  for instructions.
hinge pin on mulching plug assembly. See Figure
3-6.
Lower the mulching plug. Do not remove
side mulching plug at any time even when you
are not mulching.
9.
Follow the steps below to install the mulching baffle:
a.   catcherLift the rearup anddischargeoff of thedoorpivotandrod,lift iftheinstalled.grass
b.   Insertand releasethe mulchingthe rearbaffledischargeas showndoor.in Figure 3-5
A
A
WARNING
Never operate mower
unless the hooks on
the grass catcher are
firmly seated on the
pivot rod and the rear
discharge door rests
firmly against top of
the grass catcher.
B
B
Figure 3-6: Installing the side discharge chute.
Figure 3-5:The mulching baffle
Adjustments
Cutting Height
Drive Control
The cutting height adjustment lever is located  above the
The adjustment wheel is located in the drive control
handle housing and is used to tighten or loosen the
drive belt. You will need to adjust the drive control if
the mower does not propel itself with the drive control
engaged or if the mower’s wheels hesitate with the drive
control engaged. If either of these conditions  occur,
rotate the adjustment wheel clockwise to tighten  the
cable or counterclockwise to loosen  the cable. See
Figure 3-8.
rear left wheel. See Figure 3-7.
a.   Pull the lever out and away from the mower.
b.   Moveheight.the lever forward or back for desired cutting
c.   Release lever towards mower deck.
CUTTING HEIGHT
For rough or uneven
lawns, move the height
adjustment lever to a
higher position. This will
help prevent scalping of
the grass.
B
C
A
DRIVE CONTROL
For some people the
drive control may not
be in a comfortable
position. You can adjust
the handle by tightening
the adjustment wheel.
Figure 3-8:The adjustment wheel on the drive  control.
Figure 3-7:The cutting height adjustment lever.

Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals
Tags
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 20 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website