FINAL ADJUSTMENTS
Cable Guide
Auger and Traction Control Clutch
Adjustment
To check the adjustment of either drive clutch, push
forward on the clutch grip (depress the rubber
bumper). There should be slack in the cable.
Release the clutch grip. The cable should be
straight, but not tight. Make certain you can depress
the clutch grip against the handle completely.
Figure 6
If necessary, thread lock-nut up to increase tension
or down to decrease tension. See Figure 7.
11.
12.
13.
If not already attached, slip the cables that run
from the handle panel to the chute into the cable
guide located on top of the engine. See Figure
6.
Skid Shoe Adjustment (See Figure 8)
Unwrap the headlight wire which is attached to
the headlight, beneath the handle panel. Wind
the headlight wire around the right handle until
excess slack is removed.
The space between the shave plate and the ground
can be adjusted. For close snow removal, place skid
shoes in the low position. Use middle or high
position when area to be cleared is uneven. See
Figure 8.
Adjust skid shoes by loosening the six hex nuts and
carriage bolts and moving skid shoes to desired
position. Make certain the entire bottom surface of
skid shoe is against the ground to avoid uneven
wear on the skid shoes. Tighten nuts and bolts
securely. The skid shoes may be reversed for even
wear.
Plug the wire from the headlight into the wire
lead coming from the right side of the engine,
underneath the fuel tank.
Cable
Shift Lever Adjustment (See Figure 9)
If unit does not engage properly into first gear, it may
be necessary to remove the cotter pin and washer
from the shift rod and thread the ferrule one
counterclockwise turn.
Lock Nut
Figure 7
TIRE PRESSURE (Pneumatic Tires)
The tires are over-inflated for shipping purposes.
Check tire pressure and reduce to 15 to 20 psi.
High
Middle
Low
(Check
sidewall
of
tire
for
manufacturer’s
recommendation)
Hex Nuts
Carriage Bolts
Skid
Shoe
NOTE: If the tire pressure is not equal in both tires,
the unit may pull to one side or the other.
Figure 8
Ferrule
Flat Washer
Cotter Pin
Shift Rod
Figure 9
6
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 1333 SWE, MTD 1333 SWE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)