SECTION4: OPERATINGYOURSNOWTHROWER
Before Starting
•
After making sure no bystanders or obstacles are in
front of the unit, engage the auger control handle.
See Figure 11. As the snow thrower starts to move,
maintain a firm hold on the handle, and guide the
snow thrower along the path to be cleared.
WARNING: Read, understand, and follow
all instructions and warnings on the machine
and in this manual before operating.
•
Release the auger control handle to stop the snow
throwing action and the forward motion.
•
The spark plug wire was disconnected for safety
purposes during assembly. Attach spark plug wire
to spark plug before starting.
Press auger
control handle
to engage
auger
Fuel & Oil Mixture
WARNING:
Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel machine indoors or while the
engine is hot or running. Extinguish cigarettes,
cigars, pipes and other sources of ignition.
Turn handle
to change
discharge
direction
Your snow thrower uses a two cycle engine that
requires a mixture of gasoline and two cycle engine
oil. Refer to the engine operator’s manual for proper oil
and fuel recommendations.
Figure 11
Stopping Engine
•
•
A plastic cup was provided inside the fuel fill
opening on the fuel tank. Remove and discard this
cup before filling up the tank. Use the seperate fuel
tank cap to close after fill-up.
Run the engine for a few minutes before stopping to
help dry any moisture on the engine.
To stop engine: Turn ignition key to OFF position
and remove it from the snow thrower.
•
Starting Engine
IMPORTANT: Keep the ignition key in a safe place.
Engine will not start without it.
•
To start the engine of your snow thrower, follow the
engine manual.
•
Wipe all snow and moisture from the unit. Move the
choke lever back and forth several times and leave
it in the ON position.
Operating Snow Thrower
Upper
Discharge
Chute
Operating Tips
•
Discharge snow downwind whenever possible.
Slightly overlap each previously cleared path.
Lifting up on the handle will allow the rubber on the
augers to propel the snow thrower forward. Pushing
downward on the handle will raise the augers off
the ground and stop the forward motion.
•
Hand
Knob
NOTE: Excessive upward pressure on the handle will
result in premature wear on the rubber auger blades
which would not be covered by warranty.
•
Run the engine for a few minutes before stopping to
help dry any moisture on the engine.
Figure 10
•
Clean the snow thrower thoroughly after each use.
•
Adjust the upper discharge chute up or down as
shown in Figure 10. Then use the chute crank to
position the discharge chute in order to discharge
snow with the wind.
WARNING: Muffler, engine and surrounding
areas become hot and can cause a burn. Do
not touch.
8
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 421R, MTD 31AH4Q3G100, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)