MTD Cub Cadet 600 Series Snow Blower Owners Manual

SECTION 2:  SETTING UP YOUR SNOW THROWER
NOTE:  The   snow  thrower  is  shipped   with  oil  and
WITHOUT   GASOLINE.    After   assembly,   refer    to
separate engine manual for proper fuel and engine oil
recommendations.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and changing speed or direction of
the snow thrower will not be possible.
Unpacking
Cut along corners of the carton and lay it down flat.
Remove packing material.
Remove any loose parts included with unit (i.e.,
operator’s manual, etc.).
Roll unit out of carton. Check carton thoroughly for
any remaining loose part.
1
Panel varies
by model
Loose Parts
Your snow thrower has been assembled at the factory
except the parts shipped loose in the carton. These are
listed below.
a.   Electric Start Cord (optional)
b.   Shear Pins and Cotter Pins
Before Assembly
Disconnect spark plug wire and ground it against the
Figure 1
engine to prevent unintended starting.
NOTE: All references in this manual to the left or right
side of the snow thrower is from the operating position
only. Exceptions, if any, will be specified.
2
NOTE: This Operator’s Manual covers several models,
handle  panels,   lights  and   chute  cranks   are  some
features  that  may   vary  by  model.  Not   all  features
referenced   in   this   manual   are    applicable   to   all
snowthrower models.
Connector
Shift Rod
Setting up the Snow Thrower
Handle
1.
Observe the lower rear area of the snow thrower to
be sure both cables are aligned with roller guides
before pivoting the handle upward until it clicks into
the place. See Figure 1.
3
Handle Knob
2.
3.
Slide the shift rod connector down over the end of
the lower shift rod. Tap the connector until it locks
over the lower shift rod. See Figure 2.
Tighten two handle knobs firmly to secure the
upper handle to the lower handles. See Figure 1.
Figure 2
5
Product Specification
CategoriesCub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 52 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website