Chute Directional Control
The chute directional control is located on left side of
the snow thrower. See Figure 5.
The drive control also locks the auger control so you
can turn the chute directional control without
interrupting the snow throwing process. If the auger
control is engaged along with the drive control, the
operator can release the auger control (on the left
handle) and the augers will remain engaged. Release
both controls to stop the augers and track drive.
To change the direction in which snow is thrown, turn
chute directional control as follows:
•
•
Clockwise to discharge to the left.
Counterclockwise to discharge to the right.
IMPORTANT: Always release drive control before
changing speeds.
Clean-Out Tool
The clean-out tool is designed to clear a clogged chute.
Refer to page 10 for instructions on how to properly use
it.
Auger Drive Control
The auger drive control is located on the left handle.
Squeeze the control grip to engage the augers.
Release to stop the snow throwing action. (Drive
control must also be released.) See Figure 5.
WARNING: Never use your hand to clear
a clogged chute. Shut off engine and remain
behind handles until all moving parts have
stopped before unclogging. Use the clean-
out tool or a stick to unclog.
IMPORTANT: Refer to Auger Control Test on page 9 prior
to operating your snow thrower. Read and follow all
instructions carefully and perform all adjustments to
verify your snow thrower is operating safely and
properly.
Track Steering Controls
The left and right track steering controls are located on
the underside of the handles and they are used to
assist in steering the snow thrower. Squeeze the right
track control when turning right, squeeze the left control
when turning left. Operate your snow thrower in open
areas until you become familiar with these controls.
See Figure 5.
Chute Tilt Control
The distance snow is thrown can be changed by
adjusting the angle of the upper chute. Move the chute
tilt control forward to decrease the distance, and
backwards to increase distance. See Figure 5.
Skid Shoe
The space between the shave plate and the ground can
be adjusted by positioning the skid shoes. Refer to Skid
Shoe Adjustment on page 12.
NOTE: It is easier to maneuver a non-running snow
thrower with both track steering controls held in
simultaneously.
Throttle Control
The throttle control is located on the engine. It regulates
the speed of the engine and will shut off the engine
when pushed down completely. See Figure 5.
Shift Lever
The shift lever is located in the center of the handle
panel and is used to determine both ground speed and
direction of travel. It can be moved into any of eight
positions. See Figure 5.
Safety Ignition Key
Forward
Your snow thrower has six forward (F) speeds, with
position number one (1) being the slowest speed.
The safety ignition key must be fully inserted and
snapped in place before the unit will start. Remove the
ignition key to prevent unauthorized use of equipment.
See Figure 5.
Reverse
Your snow thrower has two reverse (R) speeds, with
position number one (1) being the slowest speed.
IMPORTANT: Do NOT attempt to turn the key.
Headlight
IMPORTANT: Always release drive control before
changing speeds.
The headlight is on whenever the engine is running.
7
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 730 STE, MTD 730 STE, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)