4
Auger Control
Four-Way Chute Control™
The chute directional control is located on the left side of
the dash panel.
• To change the direction in which snow is thrown,
squeeze the button on the joy-stick and pivot the
joy-stick to the right or to the left.
!5'%2
#/.42/,
•
To change the angle/distance which snow is thrown,
Operating
Your Snow
Thrower
pivot the joy-stick forward or backward.
#
(54%�$)2%#4)/.!,�#/.42/,
'/
#(54%�4),4�$/7.
The auger control is located on the left handle. Squeeze
the control grip against the handle to engage the augers
and start snow throwing action. Release to stop.
053(�"544/.
053(�"544/.
#(54%�2/4!4%
#(54%�2/4!4%
,%&4
2)'(4
Drive Control/ Auger Control Lock
#(54%�4),4�50
$2)6%
#/.42/,
Skid Shoes
Position the skid shoes based on surface conditions.
Adjust upward for hard-packed snow. Adjust downward
when operating on gravel or crushed rock surfaces. See
“Making Adjustment” Section.
WARNING
The operation of
Wheel Steering Controls
any snow thrower
The left and right wheel steering controls are located on
the underside of the handles. Squeeze the right control to
turn right; squeeze the left control to turn left.
'
/
can result in foreign
objects being thrown
into the eyes, which
can damage your
The drive control is located on the right handle. Squeeze NOTE: Operate the snow thrower in open areas until you
the control grip against the handle to engage the wheel
drive. Release to stop.
are familiar with these controls.
eyes severely. Always
wear safety glasses
while operating the
snow thrower, or while
performing any adjust-
ments or repairs on it.
The drive control also locks the auger control so you can
operate the chute directional control without interrupting
the snow throwing process. If the auger control is en-
Chute Clean-Out Tool
The clean-out tool is conveniently fastened to the rear of
the auger housing with a mounting clip.
gaged simultaneously with the drive control, the operator 1. Release both the auger control and the drive/auger
can release the auger control (on the left handle) and
the augers will remain engaged. Release both controls to
stop the augers and wheel drive.
control lock.
2.
Stop the engine by pushing the rocker switch to the
“OFF” position, pull out the safety key.
Be sure no one other
than the operator is
standing near the snow
thrower while starting
engine or operating
snow thrower. Never
run engine indoors or
in enclosed, poorly
ventilated areas. En-
gine exhaust contains
carbon monoxide, an
odorless and deadly
gas. Keep hands, feet,
hair and loose clothing
away from any moving
parts on engine and
snow thrower.
IMPORTANT: Always release the drive control before
3.
4
Remove the clean-out tool from the mounting clip.
changing speeds.
. removeUse theanyshovsnowel-shaandpediceenind othef thchutee cleaassembly. n-out tool to
Heated Handles Switch (If Equipped)
This switch is located on the rear of the snow thrower
dash panel. To activate the heated handles, toggle the
switch to the “ON” position to generate heat within the
handle grips. Toggle the switch to the “OFF” position
after using the snow thrower.
NOTE: The heated handles grips are a compliment to,
not a substitute for, proper cold weather outerwear for
the operator’s hands. It is recommended that the snow
thrower operator wear gloves/mittens to avoid extremities
of winter while operating this equipment.
5. Rthee-frearasteofn tthehe caugerlean-ohousingut tool toandtherestartmountiengine.ng clip on
6
. While standing in the operator’s position (behind the
snow thrower), engage the auger control for a few
seconds to clear any remaining snow or ice from the
chute assembly before continuing to clear snow.
WARNING: Never use your hands to
clean snow and ice from the chute
assembly or auger housing.
Headlight
Augers
The headlight is on whenever the engine is running.
When engaged, the augers rotate and draw snow into
the auger housing.
9
| Categories | Cub Cadet Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Cub Cadet 769-04210, MTD 769-04210, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)