6
Maintaining
Your Snow
Thrower
2.
3.
Remove the plastic belt cover, located near the
engine, by removing the three self-tapping screws that
secure it. See Figure 6-4.
a. Loosen the bolt shown in Figure 6-5 securing the
belt keeper bracket and remove the other bolt.
b. Push the belt keeper and bracket up off the engine
pulley. See Figure 6-5.
Auger Belt
4
. Remove the clip and flat washer from the ferrule in
order to disconnect the auger idler rod from the brake
bracket assembly. See Figure 6-6.
5.
6.
Slip the auger belt (the front belt) off the engine pulley.
Pull the brake bracket assembly towards the cable
guide roller and unhook the auger cable “Z” fitting.
See Figure 6-7.
Figure 6-6
7.
From both sides of the the frame assembly, use a 1/2”
wrench to remove the three hex tap screws securing
the frame to the auger housing assembly. See Figure
6-8.
IMPORTANT
NEVER replace the
auger shear pins with
standard pins. Any
NOTE: Do not remove the lower hex flange lock nut
on each side.
damage to the auger
gearbox or other com-
ponents, as a result of
doing so, will NOT be
covered by your snow
thrower’s warranty.
Figure 6-7
Check the condition
of both auger belt and
drive belt every 25
hours of snow thrower
operation. Replace if
either shows signs of
wear and tear.
Figure 6-4
Specifications are
subject to change
without notification or
obligation. Images may
not reflect your exact
model and are for refer-
ence purposes only.
Remove
Figure 6-8
Loosen
Figure 6-5
17
| Categories | Gold Snow Blower Manuals, MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | Gold 769-04179, MTD 769-04179, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)