Belt
Cover
Friction
Wheel
Self-Tapping
Screws
Support
Bracket
Rear Auger
Belt
Frame
Figure 20
•
Roll the front and rear auger belts off the engine
pulley. See Figure 21.
Front Auger
Pulley
Support
Bracket
Spring
Rear Auger
Belt
Drive
Belt
Auger
Pulley
Auger
Housing
Engine
Pulley
Idler
Spring
Front Auger
Belt
Figure 22
Idler
Pulley
Drive Belt
•
•
Follow steps 1 through 4 of previous instructions.
Pull idler pulley up, and lift belt off engine pulley
and friction wheel disc. See Figure 21.
•
•
Back out the stop bolt until the support bracket
rests on the auger pulley. See Figure 23.
Slip belt between friction wheel and friction wheel
disc. Remove and replace belt. Reassemble
following the instructions in reverse order.
Idler
Pulley
Engine
Pulley
Figure 21
NOTE: The support bracket must rest on the stop bolt
•
•
Unhook the idler spring from the hex bolt on the
auger housing. See Figure 22.
Back out the stop bolt to allow the belts to slip
between the bolt and auger pulley. See Figure 23.
after the new belt has been assembled. See Figure 23.
Friction
Wheel
Disc
Friction Wheel
Drive Belt
NOTE: It may be necessary to loosen the six hex nuts
that fasten the frame to the auger housing.
Stop
Bolt
•
Lift the rear auger belt from the auger pulley, and
slip belt between the support bracket and the auger
pulley. See Figure 22. Repeat this step for front
auger belt.
•
Replace both auger drive belts by following
instructions in reverse order.
Support Bracket
Figure 23
15
| Categories | MTD Snow Blower Manuals, Snow Blower Manuals |
|---|---|
| Tags | MTD H660G, MTD Snow Blower Manual |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Snow Blower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)