5
7.
Install the blade adapter on the crankshaft with the
“star” away from the engine. See Figure 12. Place
the blade with the side marked “bottom” (or with part
number) facing away from the adapter. Align the blade
bell support over the blade with the tabs in the holes
of the blade and insert the hex bolt.
8.
Tighten the hex bolt to the torque listed below:
Maintenance
Blade Mounting Torque
Center Bolt 450 in. lb. min., 600 in.lb. max.
To insure safe operation of your unit, ALL nuts and bolts
must be checked periodically for correct tightness.
Belt Care
1.
Remove two shoulder screws securing front drive
cover to mower deck. See Figure 13. Press inward on
sides of front drive cover and release tabs that secure
it to the height adjuster brackets. Remove drive cover
from mower.
WARNING
Figure 12
2.
3.
Pull up on the belt keeper wire and pivot it out away
When removing the
cutting blade or belt,
protect your hands
with a pair of heavy
gloves or use a heavy
rag to hold the blade.
from the drive pulley. See Figure 6 inset.
Roll the belt off the transmission pulley. Tip mower
on its side with the air filter up to access belt from
underside of mower. Slide belt off of engine pulley and
thread through the opening in the belt keeper bracket.
Then remove the belt from around the blade by remov-
ing over one end at a time. See Figure 7.
1
2
3
4.
Replace with new belt, working around blade and up
through the belt keeper bracket. Make sure belt is
firmly seated on engine pulley while pulling from the
other side and sliding it around the transmission pul-
ley. Pivot the belt keeper wire back into its operating
postion and snap into the slot provided. Reassemble
front drive cover.
An unbalanced blade
will cause excessive
vibration when rotat-
ing at high speeds. It
may cause damage
to mower, and could
break causing per-
sonal injury.
Off-Season Storage
The following steps should be taken to prepare your lawn
mower for storage.
Figure 13
1.
2.
3.
4.
5.
Cleanthe lubricationand lubricateinstructions.mower thoroughly as described in
Weor gardendo nothoserecommendto cleantheyouruseunit.of a pressure washer
We do not recommend
the use of pressure
washers or garden
hose to clean your
Refer to engine manual for correct engine
storage instructions.
Coat mower’s cutting blade with chassis grease to
prevent rusting.
unit. These may cause
damage to electrical
components, spindles,
pulleys, bearings, or
the engine. The use
of water will result in
shortened life and
Store mower in a dry, clean area. Do not store next to
corrosive materials, such as fertilizer.
NOTE: When storing any type of power equipment in
a poorly ventilated or metal storage shed, care should
be taken to rust-proof the equipment. Using a light oil or
silicone, coat the equipment, especially cables and all
moving parts of your lawn mower before storage.
reduce serviceability.
Figure 14
11
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals |
|---|---|
| Tags | MTD 560 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)