MTD Troy-Bilt 521 Lawn Edger Lawn Mower Owners Manual

6
Replacing the Drive Belt
IMPORTANT:  To aid in reassembly, note the orientation
of the drive belt on the two idler pulleys and the engine
flywheel pulley prior to performing the following  steps.
Refer to Fig. 6–3.
The edger drive belt is subject to wear and should be
replaced if any signs of cracking, shredding or rotting  are
present. To replace the belt, proceed as follows:
Flange lock nut
Maintaining
and Servicing
Your Edger
1.
2.
3.
4.
Working in front of the edger, loosen the flange lock
nut on top of frame, allowing the idler pulley assembly
to pivot slightly out from the frame. See Fig. 6–3.
With your other hand, carefully reach under the
rear of the unit and remove the belt from around the
engine flywheel pulley. See Fig. 6–3.
Engine flywheel
pulley
Remove the spindle sheaves belt guard by removing
the two self-tapping screws which secure it to the
blade plate assembly. See Fig. 6–4.
Figure 6–3
Carefully remove the belt from off of the pulleys,
again making sure to note the orientation of the belt.
Discard the belt. See Fig. 6–4.
5.
Working from the front of the edger, place the belt
onto the spindle sheaves, route it back onto the
two idler pulleys, and then place it onto the engine
flywheel pulley.
WARNING
Never operate the
edger without the
spindle sheaves belt
guard in place.
IMPORTANT:  Make certain that the “V” side  of the belt
is seated into the top pulley and the flat side of the belt is
seated into the bottom pulley. See Fig. 6–3.
Belt guard
6.
7.
Reinstall the spindle sheaves belt guard with the  self
tapping screws removed earlier.
Make certain that the drive belt is on the engine
flywheel pulley and idler pulleys, and retighten the
flange lock nut on the top of the frame.
IMPORTANT:  Make certain that the drive belt is seated
correctly and that it is riding smoothly  on the spindle
sheaves and is not pinched between them. Repeat the
first three steps if the belt is pinched.
WARNING:  Never operate  the edger
without the spindle sheaves belt
guard in place.
Engine flywheel
pulley
Figure 6–4
NOTE: Specifications are
subject to change without
notification or obligation.
Images my not reflect your
exact model and are for
reference purposes only.
11
Product Specification
CategoriesLawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals
Tags,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 16 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Lawn Mower
Product TypeWalk Behind Mower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field

Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website