3
6.
7.
The battery pack within the Electric Starter must be
charged 8 to 10 hours before use. Refer to “Charging
Battery” in the Maintenance section for instructions.
To assemble the grasscatcher:
!
a. Place bag over frame (black plastic side is the
bottom of bag.) Insert the hooks on the frame
through the holes in the side plastic channels of
the bag. See Figure 3-6.
Setup and
Adjustments
b. Secure bag to frame by working the plastic chan-
nels on bag over frame as shown in Figure 3-6.
All of the plastic channels except center top of bag
attach from the outside of bag. Center top of bag
attaches from the inside of bag.
#
"
8.
Attaching Grass Catcher to Mower
a. Lift the rear discharge door on the mower, and
place the grass catcher on the pivot rod. Let go
of discharge door so that it rests on the grass
catcher. See Figure 3-7.
NOTE: Make certain
bag is turned right side
out before assembling
(warning label will be on
the outside).
Figure 3-6
WARNING: Never operate mower
unless the hooks on the grass
catcher are firmly seated on the
pivot rod, and the rear discharge
door rests firmly against top of
the grass catcher.
NOTE: Make certain
cables are routed to the
outside of the handle so
they are not in the way
when attaching the grass
catcher.
"
!
9.
To remove grass catcher and utilize the mulching
feature:
a. Lift rear discharge door on the mower as shown in
Figure 3-7. Lift grass catcher up and out, off of the
pivot rod. Release rear discharge door to allow it to
close rear opening of mower.
Figure 3-
10.
The side discharge is an optional feature.
If converting to side discharge, make sure grass
catcher is off unit and rear discharge door is closed.
a. mOnulthechinsideg pluofg.theSeemowerFiguredeck,3-9. lift the hinged
WARNING
Never operate mower
unless the hooks on
the grass catcher are
firmly seated on the
pivot rod, and the
rear discharge door
rests firmly against
top of the grass
b. Slide the two hooks on the side discharge deflec-
tor under the hinge pin on the hinged mulching
plug assembly. Lower the hinged mulching plug.
catcher.
Figure 3-8
NtimOeT,Ee:vDenownohterneymoouvaertehenohtinmguelcdhminugl.ching plug at any
Attaching Rear Wheels (If Not Already Attached)
Remove the hex flanged nut on the rear axle from
each side and place the rear wheel on the axle.
Make sure the spring washer is on the inside of the
wheel between the wheel and the lawnmower. See
Figure 3-8. Reinsert the flanged nut into the axle as
shown, and tighten securely. Repeat on other side.
All mowers are
equipped with a rear
protective guard. The
guard helps eliminate
projectiles thrown
by the blade from
injuring the operator.
DO NOT REMOVE
THIS GUARD.
10.
Figure 3-9
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Tags | MTD 561.Troy-Bilt 561 |
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Product Type | Walk Behind Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)