6
Maintaining
Your Lawn
Tractor
Cutting Blades
WARNING: Be sure to shut the engine
off, remove ignition key, disconnect the
spark plug wire(s) and ground against
the engine to prevent unintended starting
before removing the cutting blade(s) for
sharpening or replacement. Protect your
hands by using heavy gloves or a rag to
grasp the cutting blade.
WARNING: Periodically inspect the blade
spindles for cracks or damage, especially
if you strike a foreign object. Replace
immediately if damaged.
The blades may be removed as follows.
1.
Remove the deck from beneath the tractor, (refer to
Cutting Deck Removal on page 25) then gently flip
the deck over to expose its underside.
Figure 6-
2.
Place a block of wood between the center deck hous-
ing baffle and the cutting blade to act as a stabilizer.
See Fig. 6-5.
WARNING
3.
4.
Remove the hex flange nut that secures the blade to
Be sure to shut
the spindle assembly. See Fig. 6-5.
the engine off,
To properly sharpen the cutting blades, remove equal
amounts of metal from both ends of the blades along
the cutting edges, parallel to the trailing edge, at a
remove ignition key,
disconnect the spark
plug wire(s) and
ground against the
engine to prevent
unintended starting
before removing
the cutting blade(s)
for sharpening or
replacement. Protect
your hands by using
heavy gloves or a rag
to grasp the cutting
blade.
25°
to 30° angle.
IMPORTANT: If the cutting edge of the blade has already
been sharpened to within 1 5/8” from the edge, or if any
metal separation is present, replace the blades with new
ones. See Fig. 6-6.
•
It is important that each cutting blade edge be ground
equally to maintain proper blade balance.
Figure 6-6
•
When replacing the blade, be sure to install the blade
with the side of the blade marked ‘‘Bottom’’ (or with
a part number stamped in it) facing the ground when
the mower is in the operating position.
IMPORTANT: Use a torque wrench to tighten the blade
spindle hex flange nut to between 70 foot-pounds and 90
foot-pounds.
Periodically inspect
the blade spindles for
cracks or damage,
especially if you strike
a foreign object.
Fuses
•
•
•
A fuse is installed in your tractor’s wiring harness to
protect the tractor’s electrical system from damage
caused by excessive amperage.
If the electrical system does not function, or your
tractor’s engine will not crank, first check to be certain
that the fuse has not blown.
It can either be found under the hood mounted behind
the top of the dash panel on the support bar, or under
the seat mounted to the inside of the tractor frame
next to the battery tray.
Replace immediately if
damaged.
Always use a fuse
with the same
amperage capacity for
replacement.
IMPORTANT: Always use a fuse with the same amper-
age capacity for replacement.
3
| Categories | Lawn Mower Manual, MTD Lawn Mower Manuals, Troy-Bilt Lawn Mower Manuals |
|---|---|
| Download File |
|
| Document Type | Owner's Manual |
| Language | English |
| Product Brand | MTD, Lawn Mower |
| Document File Type | |
| Publisher | mtdproducts.com |
| Wikipedia's Page | MTD Products |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)