MTD White Outdoor 855 4×4 Snow Blower Owners Manual

SECTION2:  ASSEMBLINGYOURSNOWTHROWER
NOTE: Any reference in this manual to the left or right
side   of   the  snow   thrower   is   observed   from   the
operator’s position.
Raise the upper handle assembly until it locks over
the lower handle.
Look at lower rear of snow thrower frame to be sure
both cables are aligned with cable roller guides.
See Figure 3.
Unpacking
Remove staples from the top sides and ends of the
shipping crate.
Set panel aside to avoid tire punctures or personal
injury.
Remove and discard plastic bag that covers unit.
Remove any loose parts included with unit (i.e.,
Operator’s Manual, etc).
Roll unit out of crate.
Loose Parts
The augers are secured to the auger shaft with two  
shear bolts and hex lock nuts. If you hit a foreign object
or ice jam, the snow thrower is designed so that the
bolts may shear. Two replacement shear bolts and nuts
are provided for your convenience. Store in a safe
place until needed. See Figure 1.
Check cables
on roller guides
Cable Roller
Guides
Figure 3
Shear Bolts
Hex Lock
Nuts
Secure the upper handle and lower handle with the
two plastic wing knobs, cupped washers and
carriage bolts previously removed and tighten the
upper two plastic wing nuts. See Figure 4.
Figure 1
Upper
Shift Rod
Assembly
Shift Rod
Connector
Disconnect the spark plug wire and
ground it against the engine to prevent
unintended starting.
Lower
Shift Rod
Remove the lower two plastic wing nuts, cupped
washers and carriage bolts from each side of the
lower handle. See Figure 2.
Wing Nuts
Lower
Handle
Handle
Panel
Figure 4
Slide the shift rod connector down over the end of
the lower shift rod. Tap the connector until it locks
on the lower shift rod. See Figure 4.
NOTE: If the connector is not properly assembled, the
shift rod will pivot and you will not be able to shift gears
or change directions.
Upper Handle
If not already attached, slip the cables that run from
the handle panel to the chute into the cable guide
on top of the engine. See Figure 5.
Wing Nuts,
Washers, & Bolts
Figure 2
5
Product Specification
CategoriesMTD Snow Blower Manuals, Snow Blower Manuals, White Outdoor Snow Blower Manuals
Tags, ,
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 28 pages
Document TypeOwner's Manual
LanguageEnglish
Product BrandMTD, Snow Blower
Document File TypePDF
Publishermtdproducts.com
Wikipedia's PageMTD Products
CopyrightAttribution Non-commercial
(1 votes, average: 5 out of 5)
Lawn and Garden readers have rated MTD White Outdoor 855 4×4 Snow Blower Owners Manual 5.0 out of 5.0 based on 1 product reviews.
Submit your review (optional)
(will not be displayed)
* Required Field

MTD White Outdoor 855 4×4 Snow Blower Owners Manual SKU UPC Model
Pierre on Feb 08, 2013.



Leave a Reply

Your email address will not be published. Required fields are marked *

*
*
Website